A novel method of airfoil model construction was developed. This Laminated Sheet technique uses 0.8 mm thick sheets of A286 containing a network of pre-formed channels which are vacuum brazed together to form the airfoil. A 6.25 percent model of the X29A canard, which has a 5 percent thick section, was built using this technique. The model contained a total of 96 pressure orifices, 56 in three chordwise rows on the upper surface and 37 in three similar rows on the lower surface. It was tested in the NASA Langley 0.3 m Transonic Cryogenic Tunnel. Unique aerodynamic data was obtained over the full range of temperature and pressure. Part of the data was at transonic Mach numbers and flight Reynolds number. A larger two dimensional model of the NACA 64a-105 airfoil section was also fabricated. Scale up presented some problems, but a testable airfoil was fabricated.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Technology for pressure-instrumented thin airfoil models


    Beteiligte:

    Erscheinungsdatum :

    01.09.1988


    Medientyp :

    Report


    Format :

    Keine Angabe


    Sprache :

    Englisch




    "Blended airfoil technology"

    Emerald Group Publishing | 2003


    Improved thin-airfoil theory

    ZEDAN, M. F. / ABU-ABDOU, K. | AIAA | 1988


    Theoretical pressure distributions for thin airfoil oscillating in incompressible flow

    Postel, E.E. / Leppert, Jr., E.L. | Engineering Index Backfile | 1948


    Instrumented Vehicle Studies of Traffic Flow Models

    McDonald, M. / Brackstone, M. / Sultan, B. et al. | British Library Conference Proceedings | 1998


    Finite state induced flow models. I - Two-dimensional thin airfoil

    Peters, David A. / Karunamoorthy, Swaminathan / Cao, Wen-Ming | AIAA | 1995