A differential equation governing the geometry of a two-dimensional ballute in hypersonic flow and its constraining boundary conditions are derived under idealized assumptions. By solving these equations, the shape of the ballute is determined over a range of conditions. Lift, drag, pitching moment, and the allowed limit of center-of-gravity location for stability (meta-center) are then calculated using Newtonian hypersonic approximation. It is shown that the meta-center occurs near the forward end because of compliance of the ballute membrane to the shock layer pressures, especially at low free-stream densities. In order for the vehicle employing the ballute to be stable at all densities, the center of gravity must be within approximately the forward 20 percent of overall length of the vehicle. However, typical flight trajectories of an aeroassisted orbital transfer vehicle employing the ballute for aerobraking show that the vehicle may be able to complete its atmospheric flight without tumbling provided that the center of gravity is located within the forward 43 percent of the vehicle length because of the relatively short duration of flight through the destabilizing low-density regime.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Theory of idealized two-dimensional ballute in Newtonian hypersonic flow


    Beteiligte:
    Park, C. (Autor:in)

    Erscheinungsdatum :

    01.01.1986


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Keine Angabe


    Sprache :

    Englisch


    Schlagwörter :