Published aircraft surface waviness and boundary layer transition measurements imply that currently achievable low levels of surface waviness are compatible with the natural laminar flow (NLF) requirements of business and commuter aircraft, in the cases of both metallic and composite material airframes. The primary challenge to the manufacture of NLF-compatible surfaces is two-dimensional roughness in the form of steps and gaps at structural joints. Attention is presently given to recent NASA investigations of manufacturing tolerance requirements for NLF surfaces, including flight experiment results.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Manufacturing tolerances for natural laminar flow airframe surfaces


    Beteiligte:
    Holmes, B. J. (Autor:in) / Obara, C. J. (Autor:in) / Martin, G. L. (Autor:in) / Domack, C. S. (Autor:in)

    Erscheinungsdatum :

    01.04.1985


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Keine Angabe


    Sprache :

    Englisch




    Manufacturing Tolerances for Natural Laminar Flow Airframe Surfaces

    Holmes, Bruce J. / Domack, Christopher S. / Obara, Clifford J. et al. | SAE Technical Papers | 1985


    Step Excrescence Effects for Manufacturing Tolerances on Laminar Flow Wings

    Drake, Aaron / Bender, Anne / Korntheuer, Andrea et al. | AIAA | 2010


    STEP EXCRESCENCE EFFECTS FOR MANUFACTURING TOLERANCES ON LAMINAR FLOW WINGS

    Drake, A. / Bender, A. / Korntheuer, A. et al. | British Library Conference Proceedings | 2010