Requirements for ohmic contacts to laser diodes are discussed, and properties of Schottky barrier tunneling contacts are reviewed. A procedure is described for measuring contact resistance on fabricated laser material without the need for specially constructed samples and contact configurations. Measurements of contact resistance and estimates of specific contact resistance are given for Ti/Pt/Au contacts to surfaces with three different doping levels. It was found that below a p-type carrier concentration of 1 x 10 to the 19th per cu cm the contact resistance is likely to be too high for good device performance. At higher doping levels, a specific contact resistance as low as 2 x 10 to the -6th ohm sq cm was obtained. Oxide stripe lasers provided with the type of contact discussed in this paper have been operated without failures for periods up to 7 years at a current density at the contact of 6-8 kA/sq cm. It appears therefore that these contacts satisfy the need for low resistance and durability and that, at the same time, they do not cause any obvious material degradation.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Ohmic contacts for laser diodes


    Beteiligte:
    Ladany, I. (Autor:in) / Marinelli, D. P. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1983-03-01



    Medientyp :

    Sonstige


    Format :

    Keine Angabe


    Sprache :

    Englisch




    Ohmic contacts to silicon carbide

    Shier, J. S. | NTRS | 1970


    Better Ohmic Contacts For InP Semiconductor Devices

    Weizer, Victor G. / Fatemi, Navid S. | NTRS | 1995



    Non-Invasive Optical Characterizations of OHMIC Contacts

    IEEE; Lasers and Electro-Optics Society | British Library Conference Proceedings | 1994


    Formation Of Ohmic Gold Contacts On Epitaxial GaAs

    Hecht, Michael H. / Bell, L. Doug / Kaiser, William J. | NTRS | 1991