The magnitude of the trim drag incurred by advanced supercritical wings and conventional wide-body wings at cruise conditions are investigated. Experiments were performed in a transonic pressure tunnel at a Mach number of 0.82 with a conventional wide-body wing and supercritical wing with high aspect ratio (9.80) using one of three low-tail configurations or two T-tail configurations in order to determine the effects of horizontal tail size, location, camber and static margin. Drag measurements indicate trim drag for the supercritical wing not to be significantly higher than for the conventional wing, although the minimum drag values for the supercritical wing occurred at lower static margins than for conventional wings. Both wings exhibited a reduction in trim drag with reduced cambered tail size, and greater minimum drag increments for cambered tails than for symmetrical tails. Lower trim-drag increments were also observed for the T-tail configuration than the low tails. The increase in lift-drag ratio for the supercritical wing over the conventional wing amounted to 11% for the best tail configurations.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    A comparison of trim drag for conventional and supercritical wings


    Beteiligte:
    Jacobs, P. F. (Autor:in)

    Kongress:

    American Institute of Aeronautics and Astronautics, Aerospace Sciences Meeting ; 1983 ; Reno, NV


    Erscheinungsdatum :

    1983-01-01


    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Keine Angabe


    Sprache :

    Englisch


    Schlagwörter :