The flight instrumentation for the Viking project was established to obtain environmental data, and maximize the data obtainable from the limited number of telemetry channels. To achieve these objectives, a set of six struts were strain gaged and calibrated as load cells to obtain a complete force-time history across an interface. The force-time history can be used with an analytical model to calculate the response of any part of the structure above the instrumented interface. Special matched filters were required to reduce the flight data and derive the phase correlated loads. Flight data results from the Viking Dynamic Simulator flown in February 1974 are described in addition to ground test results used to verify the data reduction process.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Strain gaged struts and data reduction techniques to maximize quality data from spacecraft flight measurements


    Beteiligte:
    Day, F. D., III (Autor:in) / Wada, B. (Autor:in)

    Kongress:

    Advances in test measurement. ; 1975 ; Philadelphia, PA


    Erscheinungsdatum :

    01.01.1975


    Medientyp :

    Sonstige


    Format :

    Keine Angabe


    Sprache :

    Englisch





    Strain-Gaged Bolts Are Easily Prepared

    Walker, R. L. | NTRS | 1982



    Struts and landing gear including struts

    Europäisches Patentamt | 2025

    Freier Zugriff

    Frequency analysis of low flows at gaged points of the Ansung stream

    Ahn, Tae jin / Lyu, Heui Jeong / Yo, Woon Shik et al. | Springer Verlag | 1998