The report presents the results of a wind tunnel investigation of a two dimensional powered wing section model employing a trailing edge ejector flap as a combination high lift and cruise propulsion device. The concept investigated was proposed for application to STOL aircraft. Thrust augmentation data is presented for the static (zero velocity), Mach .12 and Mach .3 conditions. The compact ejector employed had a nominal inlet area ratio of 5 and produced a peak thrust augmentation ratio of 1.3 under static conditions. The thrust augmentation capability of the ejector decreased rapidly between 0 and Mach .12 to a value of approximately 1.0. Between Mach .12 and .3, the thrust produced by the ejector reduced at a much slower rate. Good high lift performance was obtained with the model in the low speed flight regime. (Author)


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Ejector Blown Lift/Cruise Flap Wind Tunnel Investigation


    Beteiligte:
    R. L. Clark (Autor:in)

    Erscheinungsdatum :

    1973


    Format / Umfang :

    123 pages


    Medientyp :

    Report


    Format :

    Keine Angabe


    Sprache :

    Englisch





    Wind Tunnel Testing of a Blown Flap Wing

    Agrawal, Devansh / Asad, Faisal / Berk, Blake M. et al. | AIAA | 2019




    Numerical Investigation of Powered High-Lift Model with Externally Blown Flap

    Jie, Li / Zhibin, Gong / Heng, Zhang et al. | AIAA | 2017