This research investigated two aspects of the aft wing structure of a joined wing SensorCraft. First, the efficacy of a novel approach for incorporating wing twist for pitch control was analyzed. This design involved adding a spanwise sliding joint into the wing structure at the lower aft spar of the vehicle's aft wing. Second, the joint section where the forward and aft wings connect and form the outboard wing was redesigned and analyzed to improve the load transmission between the wing spars. Using MSC.NASTRAN, linear and non- linear static analyses were performed to examine the efficiency of the wing twist sliding joint and the forces required to achieve sufficient angular deflections for control. MSC.Patran was then used to perform post-processing of the raw data. Several variations of sliding joint location and composite ply angles were conducted. The sliding joint produced marked improvement in angular deflection over the baseline configuration. Surprisingly, however, ply angle did not have a large effect on the resulting deflections. Additional sliding joints incorporated into the wing structure produced no notable improvements in the obtained deflections either. Although the strain induced into the structure by the aft wing twist was on the order of the aerodynamic forces alone, the force required to twist the wing was significantly reduced by adding the slit in all cases. Flutter speed did not differ notably by the addition of the slit into the aft wing, yet some reduction in buckling strength was noted. The redesigned joint planform does appear to recover some of the buckling resistance lost due to the slit.
Structural Design of Wing Twist for Pitch Control of Joined Wing Sensor Craft
2006
117 pages
Report
Keine Angabe
Englisch
Fluid Mechanics , Structural Mechanics , Aerodynamics , Deflection , Aerodynamic forces , Velocity , Forward areas , Statics , Sliding , Outboard , Structural engineering , Spars , Twist(Motion) , Angular motion , Flutter , Wings , Buckling , Pitch(Motion) , Aft wing structure , Sensorcraft , Wing twist , Joined wing , Pitch control , Sliding joints
Structural Design of Wing Twist for Pitch Control of Joined Wing SensorCraft
British Library Conference Proceedings | 2006
|Joined-Wing Sensor-Craft Configuration Design
AIAA | 2006
|Joined-Wing Sensor-Craft Configuration Design
AIAA | 2004
|Joined-Wing Sensor-Craft Configuration Design
Online Contents | 2006
|