Two prototype Rudder Roll Stabilization systems were built and installed on U.S. Coast Guard WHEC cutter during 1978 and 1979. This report documents the design, fabrication, and installation of these systems and provides guidance on their use and repair. Sufficient detail is provided to enable the reader to duplicate and install a similar system on a similar vessel; however, the design considerations which optimize the system for a specific vessel class and treated only briefly. A subsequent David W. Taylor Naval Ship Research and Development Center report which addresses these design considerations and provides trial documentation of the system effectiveness is currently in preparation. (Author)
Rudder Roll Stabilization System User's Guide
1980
50 pages
Report
Keine Angabe
Englisch
TIBKAT | 1987
|NTIS | 1986
|Rudder roll stabilization: The Dutch solution
Tema Archiv | 1990
|Computer controlled roll-stabilization by rudder
Tema Archiv | 1990
Roll stabilization by rudder is computer controlled
Tema Archiv | 1990