This study is intended to investigate the frequency dependency of significant strain due to vibratory loads in aerospace vehicle components. The notion that higher frequency; dynamic loads applied as static loads is inherently conservative is perceived as widely accepted. This effort is focused on demonstrating that principle and attempting to evolve methods to capitalize on it to mitigate undue conservatism. It has been suggested that observations of higher frequency modes that resulted in very low corresponding strain did so due to those modes not being significant. Two avionics boxes, one with its first significant mode at 341 Hz and the other at 857 Hz, were attached to a flat panel installed on a curved orthogrid panel which was driven acoustically in tests performed at NASA/MSFC. Strain and acceleration were measured at select locations on each of the boxes. When possible, strain gage rosettes and accelerometers were installed on either side of a given structural member so that measured strain and acceleration data would directly correspond to one another. Ultimately, a frequency above which vibratory loads can be disregarded for purposes of static structural analyses and sizing of typical robust aerospace components is sought.
Reducing Undue Conservatism in 'Higher Frequency'; Structural Design Loads in Aerospace Components
2012
4 pages
Report
Keine Angabe
Englisch
Undue Conservatism in Random Vibration Design Loads
NTRS | 2012
|Undue Conservatism in Random Vibration Design Loads
NTIS | 2012
|Reducing aerospace design costs
AIAA | 2000
|Conservatism in cathodic protection design
Tema Archiv | 1997
|