An unpowered semispan model of a representative turboprop configuration was tested to determine the effect of configuration modifications on the the nonmetric body and wing juncture. It is indicated that the jet off nacelle-installation drag can be approximately 25% of the cruise drag. However, the losses can be reduced to 17% by changes to the wing leading edge and nacelle intersection. Comparison of test results from a semispan nonmetric fuselage model with those from a full span metric fuselage show differences in angles of attack produced the same lift. It is found that the constant lift drag rise of the semispan model is higher because of the increased angle of attack to achieve the same lift.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Installed Nacelle Drag-Improvement Tests of an M = 0.8 Turboprop Transport Configuration


    Beteiligte:
    A. D. Levin (Autor:in) / R. C. Smith (Autor:in)

    Erscheinungsdatum :

    1983


    Format / Umfang :

    378 pages


    Medientyp :

    Report


    Format :

    Keine Angabe


    Sprache :

    Englisch





    Nacelle Strake Design for Short Takeoff and Landing Configuration with Turboprop Engines

    Keller, Dennis / Hasan, Yasim Julian / Rudnik, Ralf | AIAA | 2018


    Sources of installed turboprop noise

    BURRIN, R. / SALIKUDDIN, M. | AIAA | 1983



    An axisymmetric nacelle and turboprop inlet analysis including powersimulation

    GOLDEN, D. P. / BARBER, T. J. / CHIN, W. C. | AIAA | 1983