The early breed of slow commercial airliners did not require high-lift systems because their wing loadings were low and their speed ratios between cruise and low speed (takeoff and landing) were about 2:1. However, even in those days the benefit of high-lift devices was recognized. Simple trailing-edge flaps were in use, not so much to reduce landing speeds, but to provide better glide-slope control without sideslipping the airplane and to improve pilot vision over the nose by reducing attitude during low-speed flight. As commercial-airplane cruise speeds increased with the development of more powerful engines, wing loadings increased and a real need for high-lift devices emerged to keep takeoff and landing speeds within reasonable limits. The high-lift devices of that era were generally trailing-edge flaps. When jet engines matured sufficiently in military service and were introduced commercially, airplane speed capability had to be increased to best take advantage of jet engine characteristics. This speed increase was accomplished by introducing the wing sweep and by further increasing wing loading. Whereas increased wing loading called for higher lift coefficients at low speeds, wing sweep actually decreased wing lift at low speeds. Takeoff and landing speeds increased on early jet airplanes, and, as a consequence, runways worldwide had to be lengthened. There are economical limits to the length of runways; there are safety limits to takeoff and landing speeds; and there are speed limits for tires. So, in order to hold takeoff and landing speeds within reasonable limits, more powerful high-lift devices were required. Wing trailing-edge devices evolved from plain flaps to Fowler flaps with single, double, and even triple slots. Wing leading edges evolved from fixed leading edges to a simple Krueger flap, and from fixed, slotted leading edges to two- and three-position slats and variable-camber (VC) Krueger flaps. The complexity of high-lift systems probably peaked on the Boeing 747, which has a VC Krueger flap and triple-slotted, inboard and outboard trailing-edge flaps. Since then, the tendency in high-lift system development has been to achieve high levels of lift with simpler devices in order to reduce fleet acquisition and maintenance costs. The intent of this paper is to: (1) review available high-lift devices, their functions, and design criteria; (2) appraise high-lift systems presently in service on commercial air liners; (3) present personal study results on high-lift systems; (4) develop a weight and cost model for high-lift systems; and (5) discuss the development tendencies of future high-lift systems.
High-Lift Systems on Commercial Subsonic Airliners
1996
167 pages
Report
Keine Angabe
Englisch
Aeronautics , Aerodynamic coefficients , Attitude(Inclination) , Cost analysis , Design analysis , Leading edge flaps , Leading edges , Lift devices , Trailing edge flaps , Trailing edges , Wing loading , Wing camber , Wing slots , Commercial aircraft , Landing speed , Safety , Glide paths , European airbus , Mcdonnell douglas aircraft , Boeing aircraft , Lockheed aircraft , Bac aircraft , Aircraft noise , Nasa programs
High-Lift Systems on Commercial Subsonic Airliners
NTRS | 1996
|Design Investigation of Variable Camber Flaps for High-Subsonic Airliners
British Library Conference Proceedings | 2000
|Commercial aircraft airliners of world
Engineering Index Backfile | 1957
Booster Engines for Commercial Airliners
SAE Technical Papers | 1969
|