A manufacturing process to produce 80 single aisle sized thermoplastic composite aircraft a month is presented. Within the Hi-Rate Composite Aircraft Manufacturing (HiCAM) program a baseline aircraft fuselage was designed and modeled based on the Boeing 787 one-piece barrel build, but scaled down to a single aisle aircraft. Key Performance Parameters (KPPs) of recurring cost, non-recurring cost, and weight are calculated from the model. The outcome of this simulation indicated a prohibitively high non-recurring cost, so the thermoplastic team modeled the manufacturing flow for a panelized fuselage concept. The minimum success criteria is a 30% cost reduction and less than two percent increase in weight compared to the baseline aircraft. Automated Fiber Placement (AFP) is used to layup skins, stamp forming is used to make body frames, stringers, and passenger door surround parts. In the model, Co-Fusion was used to consolidate the skin while simultaneously welding on stringers to make stiffened panels. Additional welding technologies were considered to minimize fastener use and a vertical build concept was used for final assembly to reduce factory size. This manufacturing concept for a thermoplastic aircraft indicated a 39% cost and 12% weight savings compared to the baseline. Additional trade studies were conducted using Northrop Grumman’s Automated Stiffener Forming technology to make stringers and stamp forming instead of AFP to make skins.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Thermoplastic Aircraft Manufacturing Model


    Beteiligte:
    J. P. Heil (Autor:in) / R. E. Jones (Autor:in) / L. Kakoulias (Autor:in) / R. L. Allenbach (Autor:in) / C. Tonn (Autor:in)

    Erscheinungsdatum :

    2024


    Format / Umfang :

    16 pages


    Medientyp :

    Report


    Format :

    Keine Angabe


    Sprache :

    Englisch





    AIRCRAFT THERMOPLASTIC REINFORCEMENT PANEL MANUFACTURING APPARATUS AND METHOD

    PARK JONG HYUN / KANG JEONG SEOK / KANG CHANG SOO | Europäisches Patentamt | 2020

    Freier Zugriff

    APPARATUS AND METHOD FOR MANUFACTURING THERMOPLASTIC REINFORCED PANEL OF AIRCRAFT

    PARK JONG HYUN / KANG JEONG SEOK / KANG CHANG SOO | Europäisches Patentamt | 2020

    Freier Zugriff

    Decomposition of Thermoplastic Resins Designed for High-Rate Aircraft Manufacturing

    C. J. Wohl / R. I. Ledesma / R. J. Cano et al. | NTIS | 2024