The intent of this program is to produce tank track of the latest design using general stamping and welding methods and maintaining the same or less weight than the forged track. This program was initiated to further the development of the T150 track. The aim is to develop a light weight track shoe and end connector by stamping parts from steel plate, forming, and welding. The ability to fabricate track by this method, equal to the forged track normally used, would broaden the manufacturing base available to produce in case of national emergency. The track is presently being tested at the Nevada Automotive Test Center.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen


    Exportieren, teilen und zitieren



    Titel :

    Stamped and Welded Track for 15 - 18 Ton Vehicle


    Beteiligte:
    A. B. Kendall (Autor:in)

    Erscheinungsdatum :

    1984


    Format / Umfang :

    16 pages


    Medientyp :

    Report


    Format :

    Keine Angabe


    Sprache :

    Englisch




    STEEL TAILOR WELDED BLANK STAMPED BATTERY TRAY

    ZHU FENG / YU MIAO / NAZARI SOBHAN T et al. | Europäisches Patentamt | 2024

    Freier Zugriff

    Prospects for using aluminium-lithium alloys for stamped-welded aviations structures

    Bratukhin, A.G. / Redchits, V.V. / Lukin, V.I. | Tema Archiv | 1997


    Stamped carrier

    TOBER MARK T | Europäisches Patentamt | 2016

    Freier Zugriff

    STAMPED ENERGY ABSORPTION SIDE STRUCTURE FOR VEHICLE

    NISBET ANDREW CHARLES / CHAKRABORTY SUBHOJIT / MUIR DANIEL JEFFERSON et al. | Europäisches Patentamt | 2025

    Freier Zugriff

    STAMPED ENERGY ABSORPTION SIDE STRUCTURE FOR VEHICLE

    NISBET ANDREW CHARLES / CHAKRABORTY SUBHOJIT / MUIR DANIEL JEFFERSON et al. | Europäisches Patentamt | 2024

    Freier Zugriff