As TxDOT plans for future expansion of the states highway network, interest in higher design speeds has been expressed as a means of promoting faster and more efficient travel and movement of goods within the state. TxDOT funded project 0-6071 as part of a proactive consideration of safety on these highspeed facilities. This project began the process of developing roadside safety hardware suitable for use on high-speed highways. The impact conditions selected for the design, testing, and evaluation of this highspeed hardware include a speed of 85 mi/h and an angle of 25 degrees for barrier impacts. The design vehicles are those specified by the pending AASHTO Manual for Assessing Safety Hardware (MASH) and include a 5000-lb, 1/2-ton, 4-door pickup truck and a 2425-lb passenger car. After consideration of several barrier systems, two designs were selected for further evaluation through full-scale crash testing. These included an energy absorbing bridge rail concept and a modified wood post thrie beam guardrail. The results of the full-scale crash testing are presented and recommendations for future research are discussed.
Evaluation of Barriers for Very High Speed Roadways
2010
152 pages
Report
Keine Angabe
Englisch
Speed Control on High Speed Roadways
NTIS | 1981
|Acceleration Ramps along High Operating Speed Roadways
NTIS | 2010
|