The SpaceFibre provides numerous advantages over the SpaceWire: QoS, FDIR, high transmission rate, galvanic isolation, lower cable mass. At moderate speeds, e.g. 10–200 Mbps, the SpaceFibre interface implementation can be significantly simplified with oversampling techniques, which does not require PLLs and analog CDR blocks. It makes possible fully digital implementation of the SpaceFibre interface in a simple ASIC or FPGA. This paper presents an oversampling technique based on digital signal processing. The technique allows to enhance transmission rate, operational distance, phase/amplitude distortion tolerance and higher noise immunity in compare with the traditional edge detection method.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Advanced oversampling techniques for the SpaceFibre


    Beteiligte:


    Erscheinungsdatum :

    01.09.2014


    Format / Umfang :

    476763 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    SpaceFibre multi-lane: SpaceFibre, long paper

    Florit, Albert Ferrer / Villafranca, Alberto Gonzalez / Parkes, Steve | IEEE | 2016


    SpaceFibre Port IP Core (GRSPFI): SpaceFibre, poster paper

    Siegle, Felix / Habinc, Sandi / Both, Johannes | IEEE | 2016


    SpaceFibre networks: SpaceFibre, long paper

    Parkes, Steve / McClements, Chris / McLaren, David et al. | IEEE | 2016


    SpaceFibre Interfaces and Architectures

    Parkes, Steve / Florit, Albert Ferrer / Villafranca, Alberto Gonzalez | IEEE | 2019


    A new generation of SpaceFibre test and development equipment: SpaceFibre, short paper

    Villafranca, Alberto Gonzalez / Parkes, Steve / McClements, Chris et al. | IEEE | 2016