The objectives of this paper are to study the physics of the actuator-induced flow and to develop computational simulations of the actuator-generated flows. The vortex generator consists of a cavity with a lightweight actuator plate. The actuator plate acts like a piston pumping air out of the cavity on the down-stroke and sucking air into the cavity on the upstroke. The actuator is placed asymmetrically over the cavity opening, forming narrow and wide slots when viewed from the top. The actuator depending on amplitude, frequency, and slot spacing produces several flow fields (free jet, wall jet, vortex flow). Computational simulation of the actuator-generated flows have been developed and applied to several actuator flow modes. This work should provide an impetus for designing similar active flow control systems suitable for aircraft applications. The computational simulation uses a time-accurate full Navier-Stokes (NS) solver known as FTNS3D (a full NS version of CFL3D solver). A multi-block moving grid has been developed and used for the computational study of the flow fields produced by the vortex generator. For three-dimensional computations, ten multi-block grids are used and for two-dimensional computations, six multi-block grids are used. The grid blocks adjacent to the actuator plate move with the plate motion, and second-order interpolation is used along the block interfaces. Periodic response of the flow has been observed to develop after three cycles of the plate sinusoidal motion.
Computational and physical analysis of active vortex generators
2000 IEEE Aerospace Conference. Proceedings (Cat. No.00TH8484) ; 2 ; 121-127 vol.2
2000-01-01
786364 byte
Aufsatz (Konferenz)
Elektronische Ressource
Englisch
Computational and Physical Analysis of Active Vortex Generators
British Library Conference Proceedings | 2000
|Active Vortex Generators Using Jet Vectoring Plasma Actuators
SAE Technical Papers | 2008
|