In threading turning and grooving turning of Ti-6Al-4V alloy with a pressurized coolant supply, the effects of the coolant pressure on the cutting performance have not been reported. In this study, in threading turning and grooving turning of Ti-6Al-4V alloy with a high-pressure coolant supply, in order to identify an effective PCD tool for the high-speed cutting of Ti-6Al-4V, the effects of the diamond content and the diamond particle size on the tool wear were experimentally investigated. As the Ti-6Al-4V alloy was threading turned and grooving turned with a high-pressure coolant supplied, the chip configurations and the tool wear were experimentally investigated. The following results were obtained: (1) The effectiveness of the chip breaking performance when turning machining by supplying a high-pressure coolant was improved. In this case, the chip length became shorter as the refrigerant pressure was higher. (2) Comparing the cutting of the conventional coolant supply with the cutting of the high-pressure coolant, the tool wear was smaller than that with the low pressure coolant supply.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Cutting Performance in Threading Turning and Grooving Turning of Ti-6Al-4V Alloy with a High-Pressure Coolant Supply


    Beteiligte:
    Wada, Tadahiro (Autor:in)


    Erscheinungsdatum :

    01.07.2019


    Format / Umfang :

    309567 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch






    TURNING CONTROL DEVICE, TURNING CONTROL METHOD, AND TURNING DEVICE

    KIKUCHI NORIO / AMMA YUSUKE / SAKAKI JUN | Europäisches Patentamt | 2025

    Freier Zugriff

    TURNING METHOD AND TURNING DEVICE

    SUZUKI TAKU / OIDA TOMOAKI / MIYASHITA YUKI et al. | Europäisches Patentamt | 2023

    Freier Zugriff