Aluminum-alloy samples of slot antenna array were fabricated directly on a Nd:YAG laser cutting system and the combined effects of power and feed rate on slot size, surface roughness, and striation frequency have been studied. Regression analysis was used to develop models that describe the effect of the independent process parameters on laser cut quality of aluminum-alloy slot array. For the range of operation conditions tested, it was observed that power had a major effect on slot size, while feed rate affects were secondary. On the other hand, surface roughness and striation frequency were affected most by feed rate. At low power levels, low feed rates gave good surface roughness and low striation frequency. For optimum laser fabricating property, the surface roughness is kept at a minimum. The dimension size can be controlled within the error allowance (/spl mu/ m level), and the productivity is improved more effectively than that of other methods, such as EDM, milling. By changing the antenna from the milling slot antenna to the laser fabrication, the detected sensitivity improved by 2-3 times.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Direct laser fabrication of aluminum-alloy slot antenna array


    Beteiligte:
    Xuyue Wang, (Autor:in) / Renke Kang, (Autor:in) / Wenji Xu, (Autor:in) / Dongming Guo, (Autor:in)


    Erscheinungsdatum :

    01.01.2006


    Format / Umfang :

    2604462 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    SLOT ARRAY ANTENNA

    KAMO HIROYUKI / KIRINO HIDEKI | Europäisches Patentamt | 2018

    Freier Zugriff



    Slot-antenna array for missiles and aircraft

    Wilkinson, E.J. | Engineering Index Backfile | 1959