The assessment of damages in the aircraft components is a key aspect to avoid structural failure. In general, damages may occur due to flight load, accidents during the maintenance and environmental conditions. Primary airframes such as aircraft wings and fuselages are covered with thin aluminum alloys. The damages in the aircraft wing skins are posing a serious threat. The traditional non-destructive testing (NDT) often requires dismantling the component for inspection, consuming more time. Guided wave structural health monitoring (GWSHM) is an alternative to inspect the large structures, it is a time saving and cost-effective. However, the defect identification and localization using multi-mode and highly dispersive guided waves requires significant knowledge. In this research, multiple defects are examined by performing numerical simulation. The defect can be identified and located by measuring the Time of Flight (ToF) and delay time of a signal. The Hilbert Transform (HT) and Zero-crossing techniques are used to measure the ToF of the signal to enable defect presence and the delay time between two signals are analyzed to enable defect location.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The Defect Identification and Localization using Ultrasonic Guided Waves in Aluminum Alloy


    Beteiligte:


    Erscheinungsdatum :

    23.06.2021


    Format / Umfang :

    4320503 byte





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Steel rail bottom defect identification method based on ultrasonic guided waves

    LI XIAOLONG | Europäisches Patentamt | 2024

    Freier Zugriff



    Rail defect detection using ultrasonic surface waves

    Edwards, R.S. / Jian, X. / Fan, Y. et al. | Tema Archiv | 2006


    Ice detection by ultrasonic guided waves

    Mendig, C. / Riemenschneider, J. / Monner, H. P. et al. | Online Contents | 2018