This paper presents shaft design techniques specifically for applications in electric traction motors for hybrid electric vehicles (HEVs) and electric vehicles (EVs). The typical characteristics of several shafts used in traction motors for commercial HEVs/EVs are studied. Then, the shaft design for a 24/16 switched reluctance machine (SRM) is presented. The 24/16 SRM is designed to replace an interior permanent magnet synchronous traction motor used in an HEV application. The requirements of shaft design, design procedures, circumferential positioning, bearing positioning, and design of output end and sensor end are presented and discussed in this paper.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Shaft Design for Electric Traction Motors


    Beteiligte:
    Liang, Jianbin (Autor:in) / Jiang, James Weisheng (Autor:in) / Bilgin, Berker (Autor:in) / Emadi, Ali (Autor:in)


    Erscheinungsdatum :

    2018-09-01


    Format / Umfang :

    4214785 byte




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Motors for electric traction

    Pereda, Luis | Engineering Index Backfile | 1908


    Rules for electric traction motors

    Engineering Index Backfile | 1961


    Rules for electric traction motors

    Engineering Index Backfile | 1955


    Traction motors for electric locomotives

    Hadrill, H.F.J. | Engineering Index Backfile | 1955


    Rules for electric traction motors

    Engineering Index Backfile | 1933