To control the radiated emission of high-speed link and associated unit, the current approach is to implement overall harness shielding on cables bundles. This method is very efficient in the HF/ VHF (high frequency/ very high frequency) and UHF (ultra-high frequency) ranges when the overall harness shielding is properly bonded on EMC back-shell. Unfortunately, with the increasing frequency, the associated half wavelength matches with the size of Sub-D connector that is the case for the L band. Therefore, the unit connectors become the main source of interference emission. For the L-band and S-band, the current technology of EMC back-shell leaves thin aperture matched with the L band half wavelength and therefore, the shielding effectiveness is drastically reduced. In addition, overall harness shielding means significant increases of the harness mass. Airbus D&S Toulouse and Elancourt investigated a new solution to avoid the need of overall harness shielding. The objective is to procure EM (Electro-Magnetic) clean unit connected to cables bundles free of any overall harness shielding. The proposed solution is to implement EMC common mode filtering on signal interfaces directly on unit PCB as close as possible the unit connector. Airbus D&S Elancourt designed and manufactured eight mock-ups of LVD S (Low Voltage Differential Signaling) interface PCBs' with different solutions of filtering. After verification of the signal integrity, three mock-ups were retained (RC filter and two common mode choke coil) in addition to the reference one (without EMC filter). Airbus D&S Toulouse manufactured associated LVDS cable bundles and integrated the RX (Receiver) and TX (Transmitter) LVDS boards in shielded boxes. Then Airbus D&S performed radiated emission measurement of the LVDS links subassemblies (e.g. RX and TX boxes linked by LVDS cables) according to the standard test method. This paper presents the different tested solutions and main conclusions on the feasibility of such approach.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    High speed link radiated emission reduction


    Beteiligte:
    Bisognin, P. (Autor:in) / Pelissou, P. (Autor:in) / Cissou, R. (Autor:in) / Giniaux, M. (Autor:in) / Vargas, O. (Autor:in)


    Erscheinungsdatum :

    2016-05-01


    Format / Umfang :

    761481 byte




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    High Speed Link Radiated Emission

    Bisognin, P. / Pelissou, P. / Vargas, O. et al. | British Library Conference Proceedings | 2012


    High speed link radiated emission

    Bisognin, Patrick / Pelissou, Patrice / Vargas, Olivier et al. | IEEE | 2012



    Radiated emission and susceptibility - test methodology

    Moy,K.P. / Bailey,D.D. / Olin,J.G. et al. | Kraftfahrwesen | 1985


    Radiated emission noise of the plasma

    IJICHI, K. / YOSHIDA, T. / KUDO, I. et al. | AIAA | 1982