The paper presents the results of tests topography and surface roughness of dies used in the cold forging proces. Were tested two tools withdrawn from work due to cracks and abrasive wear. In the analyses has been used Alicona InfiniteFocus G5, the device based on the method of the focus variation microscopy. The principle of its operation and the possibilities of its use to accurately determine the topography and surface roughness tests of forging tools have been described. On the basis of the conducted tests, it has been found that the impressions are subject to a typical abrasive wear mechanism, which affects the change of their dimensions and surface roughness.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Analysis of wear of cold forging dies using the technique of focal differentiation microscopy


    Beteiligte:
    Cwikla, Adam (Autor:in) / Tofil, Arkadiusz (Autor:in)


    Erscheinungsdatum :

    01.06.2019


    Format / Umfang :

    1202758 byte





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Forging machine dies

    Anderson, H.N. | Engineering Index Backfile | 1931


    Elasto-Plastic Stress Analysis Methodology Establishment for Forging Dies

    Lomate, Dattaprasad P. / Jagtap, Govind / Patil, Mr. Abhijit et al. | IEEE | 2018


    Aluminum alloy forging dies: considerations in their design and use

    Duff, R.F. | Engineering Index Backfile | 1943


    Fundamentals of cold forging

    Gold, R. | Tema Archiv | 1986


    Tribological measurement in cold forging

    Mueller,C. / Groche,P. / Tech.Univ.Darmstadt,DE | Kraftfahrwesen | 2014