A preliminary scheme was developed for base-mounted solid-propellant retro rocket motors to self-penetrate the Orion Crew Module heat shield for configurations with the heat shield retained during landings on Earth. In this system the motors propel impactors into structural push plates, which in turn push through the heat shield ablator material. The push plates are sized such that the port created in the ablator material is large enough to provide adequate flow area for the motor exhaust plume. The push plate thickness is sized to assure structural integrity behind the ablative thermal protection material. The concept feasibility was demonstrated and the performance was characterized using a gas gun to launch representative impactors into heat shield targets with push plates. The tests were conducted using targets equipped with Fiberform® and PICA as the heat shield ablator material layer. The PICA penetration event times were estimated to be less than 30 ms from the start of motor ignition. The mass of the system (not including motors) was estimated to be less than 2.3 kg (5 lbm) per motor. The configuration and demonstrations are discussed in this paper.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Retro rocket plume actuated heat shield exhaust ports


    Beteiligte:
    Marrese-Reading, Colleen (Autor:in) / St.Vaughn, Josh (Autor:in) / Frisbee, Robert (Autor:in) / Zell, Peter (Autor:in) / Hamm, Kenneth (Autor:in) / Corliss, James (Autor:in) / Gayle, Steve (Autor:in) / Pain, Rob (Autor:in) / Rooney, Daniel (Autor:in) / Ramos, Amadi (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    2009-03-01


    Format / Umfang :

    2603836 byte





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch