One task of the Prototype Dolos Study was to develop a transfer function between incident wave conditions and the pulsating loads they produce in the instrumented prototype dolosse. The purpose of the physical model investigation was to develop and verify model technology for measuring wave-induced moments and torques at small scale. This objective was approached in the model investigation in the following manner. (a.) Reactivate the three-dimensional (3 -D) breakwater stability model used during the 1985 model tests, modify the breakwater structure to match the geometry of the 1986 dolos rehabilitation, and remold the bathymetry seaward of the breakwater to match the most recent survey information. (b.) Develop and construct instrumented model dolosse that reproduce the 42-ton prototype dolosse at the stability model scale and that are capable of measuring wave-induced pulsating loads. (c.) Incorporate the instrumented dolosse into the model and measure and record the pulsating loads induced in the dolosse by irregular wave realization of the discrete spectra that were measured in the prototype. (d.) Develop a transfer function between incident model waves and the pulsating loads they induce in the instrumented model dolosse in a similar manner as done for the prototype data. (e.) Compare the model and prototype transfer function and if needed, develop a scaling relation between them.
Crescent City Instrumented Model Dolos Study: Coastal Model Investigation
Technical Report ; CERC-92-15
1992
18021652
Report
Elektronische Ressource
Englisch
Dolos Design Procedure Based on Crescent City Prototype Data
HENRY – Bundesanstalt für Wasserbau (BAW) | 1993
|Breakwater Rehabilitation Study, Crescent City Harbor, California: Coastal Model Investigation
HENRY – Bundesanstalt für Wasserbau (BAW) | 1985
|HENRY – Bundesanstalt für Wasserbau (BAW) | 1968
|