IN the previous section it was explained how the terminal P.D. of a shunt dynamo can be adjusted manually by means of a field regulator. Although such a device may find a place where large dynamos are concerned, conditions involving a fluctuating load necessitate some form of automatic voltage control. Where a floating battery is used with the dynamo it is further desirable that the dynamo output should be suited to the state of charge of the battery, and again that it should change with every variation of load. While it would be quite possible to make all these adjustments by manual controls, such a scheme is obviously ruled out on motor vehicles and aeroplanes. The basic aim of the automatic voltage controller must, therefore, be to keep the battery fully charged, but the actual achievement of this aim turns out to involve much greater complexity than would be anticipated.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Maintenance of Electrical Equipment


    Untertitel :

    A Complete Guide for Prospective Ground Engineers Studying for an “X” Licence


    Beteiligte:
    Crook, W.E. (Autor:in)


    Erscheinungsdatum :

    01.03.1936


    Format / Umfang :

    3 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Electrical Equipment Maintenance

    Online Contents | 2001


    Electrical equipment maintenance device

    BAI LIN / WANG GANG / XU MING et al. | Europäisches Patentamt | 2024

    Freier Zugriff

    Maintenance of Electrical Equipment

    Crook, W.E. | Emerald Group Publishing | 1935


    Maintenance of Electrical Equipment

    Crook, W.E. | Emerald Group Publishing | 1936


    Maintenance of electrical equipment

    Cooper, W. | Engineering Index Backfile | 1941