THE bending moments in a strut with lateral loading can usually be found graphically by means of the Polar (Howard) Diagram, but with a strut of non-uniform section and a complex load system it is difficult to obtain an accurate solution without drawing to an inconveniently large scale. The tabular method described here is applicable to struts of varying section with any load system and involves only arithmetical calculation. The strut is divided into a convenient number of ‘simple’ segments, i.e. segments of uniform section with no point loads applied within the length of each segment, and successive applications are made of relations between the bending moment and slope at either end of the segments. Two trial solutions are necessary, from which the required solution is readily obtained.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Laterally Loaded Non-Uniform Struts


    Untertitel :

    A Tabular Method Requiring only Arithmetical Calculation


    Beteiligte:
    Gittleman, W. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1953-02-01


    Format / Umfang :

    2 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch






    Rapid estimation of stresses in uniform struts

    Francis, H.A. | Engineering Index Backfile | 1927


    Instrumentation for Laterally Loaded Model Piles

    Caliendo, Joseph A. / Anderson, Loren R. / Winward, Renέ F. et al. | Transportation Research Record | 1996