Abstract This paper presents the design of a satellite navigation receiver architecture tailored for future Lunar exploration missions, demonstrating the feasibility of using Global Navigation Satellite Systems signals integrated with an orbital filter to achieve such a scope. It analyzes the performance of a navigation solution based on pseudorange and pseudorange rate measurements, generated through the processing of very weak signals of the Global Positioning System (GPS) L1/L5 and Galileo E1/E5 frequency bands. In critical scenarios (e.g. during manoeuvres) acceleration and attitude measurements from additional sensors complementing the GNSS measurements are integrated with the GNSS measurement to match the positioning requirement. A review of environment characteristics (dynamics, geometry and signal power) for the different phases of a reference Lunar mission is provided, focusing on the stringent requirements of the Descent, Approach and Hazard Detection and Avoidance phase. The design of High Sensitivity acquisition and tracking schemes is supported by an extensive simulation test campaign using a software receiver implementation and navigation results are validated by means of an end-to-end software simulator. Acquisition and tracking of GPS and Galileo signals of the L1/E1 and L5/E5a bands was successfully demonstrated for Carrier-to-Noise density ratios as low as 5–8dB-Hz. The proposed navigation architecture provides acceptable performances during the considered critical phases, granting position and velocity errors below 61.4m and 3.2m/s, respectively, for the 99.7% of the mission time.
Design of a High Sensitivity GNSS receiver for Lunar missions
Advances in Space Research ; 57 , 11 ; 2285-2313
2016-03-10
29 pages
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
Design of a High Sensitivity GNSS receiver for Lunar missions
Online Contents | 2016
|Assisted GNSS Navigation in Lunar Missions
AIAA | 2014
|GNSS-Based Navigation for Lunar Missions
Tema Archiv | 2014
|NTRS | 2021
|NTIS | 2021
|