Abstract In-space manufacturing especially for external satellite structures has a huge potential to increase the packaging density of a satellite in launch configuration and enables large structures for advanced mission requirements. However, the processes and materials do have to withstand the harsh environmental conditions in space. These conditions have immediate effects on the manufacturing process as well as long-term effects on the structure manufactured in orbit. The experiments presented here are based on a photopolymer extrusion process by UV-radiation curing that is intended to be used as an in-space manufacturing technology. In order to understand the influence of reduced atmospheric pressure and microgravity on the process, we demonstrated the successful extrusion and curing of rod-shaped elements during a sounding rocket flight. Simultaneously, the same experiment was performed on the ground under normal gravity and ambient pressure. By comparing both groups of specimens, it was shown that the morphological artifacts and geometric deviations are more significant for the specimens manufactured during flight. This evaluation was performed by visual inspection, by comparison of the laser-scanned specimens with a reference model and by measuring and comparing the mass, length and diameter of the specimens. On a microscopic level, conducted by computer tomography, no influence of the reduced atmospheric pressure on the extrusion of the liquid photopolymer can be recognized as this was probably not low enough at the altitude reached by the rocket. As a result of this article, measures are proposed to avoid the morphological artifacts observed during the experiments and thus achieve higher accuracy and a resilient in-space manufacturing process.

    Highlights Demonstration of Photopolymer Extrusion process under microgravity and vacuum. Artifacts were identified for the specimen manufactured under microgravity and vacuum. Bubbles were identified for the vacuum-exposed specimen because of not degassed resin. The Microgravity environment showed no major influence on the specimen.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Effects of microgravity and reduced atmospheric pressure on manufacturing photopolymer specimens


    Beteiligte:
    Kringer, Michael (Autor:in) / Titz, Alexander (Autor:in) / Maier, Patricio (Autor:in) / Schill, Fabian (Autor:in) / Pimpi, Jannik (Autor:in) / Hoffman, Leonhard (Autor:in) / Lafont, Ugo (Autor:in) / Reiss, Philipp (Autor:in) / Pietras, Markus (Autor:in)

    Erschienen in:

    Acta Astronautica ; 218 ; 314-325


    Erscheinungsdatum :

    2024-01-26


    Format / Umfang :

    12 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Physical properties of MnBi specimens produced in microgravity

    PANT, P. / WIJNGAARD, J. / HAAS, C. | AIAA | 1989


    Proton magnetic resonance imaging of specimens in simulated microgravity

    Garrido, Leonico / Sampayo, Jose | Tema Archiv | 2009


    Physical properties of manganese-bismuth specimens produced in microgravity

    PANT, P. / WIJNGAARD, J. H. / HAAS, C. | AIAA | 1990



    Characterization of DuPont photopolymer

    Kyong Chul Woo, / Tea Sung Aum, / Jin Hyuk Kwon, | IEEE | 1999