AbstractPreliminary studies on the planetary entry to Jupiter by aerocapture technique are studied in order to complete technological challenges to deliver scientific probe with low cost and smaller mass of the spacecraft to Jupiter. Jupiter aerocapture corridor determination based on maximum deceleration limit of (lower corridor) and aerocapture capability (upper corridor) at Jupiter are carefully considered and calculated. The results show about 1700m/s of saving velocity due to aerocapture could be possible in some cases for the spacecraft to be captured by Jovian gravitational field. However, the results also show that Jovian aerocapture is not available in some cases. Hence, careful selection is needed to realize Jovian aerocapture.Also the numerical simulation of aerodynamic heating to the spacecraft has been conducted. DSMC method is used for the simulation of flow fields around the spacecraft. The transient changes of drag due to Jovian atmosphere and total heat loads to the spacecraft are obtained. The results show that the estimated heat loads could be within allowable amount heat load when some ablation heat shield technique is applied.
Preliminary studies on the planetary entry to Jupiter by aerocapture technique
Acta Astronautica ; 59 , 8-11 ; 651-660
2005-01-01
10 pages
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
Preliminary studies on the planetary entry to Jupiter by aerocapture technique
British Library Conference Proceedings | 2006
|Preliminary Studies on the Planetary Entry to Jupiter by Aerocapture Technique
British Library Conference Proceedings | 2003
|Preliminary studies on the planetary entry to Jupiter by aerocapture technique
Online Contents | 2006
|Aerodynamic Studies on the Planetary Entry to Jupiter by Aerocapture Technique
British Library Conference Proceedings | 2004
|Aerocapture Inflatable Decelerator for Planetary Entry
NTRS | 2007
|