This study proposes a comparative analysis of controls for controlling levels and concentrations in the CSTR process. The controller designed to analyze its performance is sliding mode. Comparison of controller performance analysis is shown by differences in sliding surfaces. The design starts with designing the dynamic sliding surface and the PID on the sliding mode controller. Then, the two controllers are combined. Analysis is done by comparing the performance of the three controllers in controlling the level and concentration of the CSTR system. The simulation results show hybrid controllers are able to reach the set point faster than the other two controllers, this is proved by the value of ts = 0.016 s for the level and ts = 0.072 s for concentration. However, sliding mode controller with PID sliding surface is a controller that is able to reduce the largest steady state error compared to the other two controllers, with the value E_ss = 0.
Analisa Performansi Pengendali Hybrid Sliding Mode (DSM) dan Sliding Mode dengan Permukaan Luncur PID Pada Proses CSTR
2019-11-26
Seminar Nasional Teknologi Informasi Komunikasi dan Industri; 2019: SNTIKI 11; 575-592 ; 2579 5406 ; 2579 7271
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
DDC: | 629 |
BASE | 2019
|ANALISA PERFORMANSI CONTROLLER PADA ARSITEKTUR JARINGAN SOFTWARE DEFINED NETWORK (SDN)
BASE | 2020
|Implementasi Multi-Mikrokontroller pada Mobile Robot sebagai Pengendali Kecepatan dengan Kendali PID
BASE | 2014
|Analisis Sistem Kendali Terbang dengan Gain Scheduling Pada Pesawat Efek Permukaan
BASE | 2017
|