Commonreasons for implementing automated vision inspection system has been discussed by previous researchers. Many advantages when compared to automated vision inspection of human visual inspection. Automated vision inspection system can work tirelessly, and has accuracy and consistent quality control. Vision inspection system can detect defects that are hard to find by the human visual. Without tools and can operate faster than the human visual. This research will use the software as mach3 CNC control system controls the computer, as the driving bipolar stepper motors, and motor driver IC that is used as a controller L297 and L298 stepper motors. Measuring instruments that are used for data retrieval using calipers. Testing is done by measuring the displacement of the desk and then compare the measured values with values that ruled on the computer simulation of translational motion as far as 1 cm, 2 cm, 3 cm, 4 cm, 5 cm, and 6 cm.From the testing that has been done on each axis movement values obtained average error as follows: on the x-axis value obtained the largest average error was 3%. Then the z axis has an average value of the largest error is 8.4%. Value of the compensation amount given step is 2 times the amount of an ideal step.Keywords: Software Mach3 CNC, Driver L297 & L298, Stepper Motor - bipolar.
Pembuatan Sistem Kendali Numerik untuk Pengerak Sistem Inspeksi Visi
2014-01-10
Jurnal Ilmiah Teknik Mesin; Vol 2, No 1 (2014)
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
DDC: | 629 |
Pembuatan Sistem Kendali Navigasi Wahana Selam Nir Awak Auv (Autonomous Underwater Vehicle)
BASE | 2013
|Kajian komputasi numerik dan eksperimental pengaruh sistem kendali aktif pada model kendaraan
BASE | 2024
|PERANCANGAN SISTEM KENDALI MENIRU BURUNG UNTUK UNMMANED AERIAL VEHICLE BERKONFIGURASI SAYAP TETAP
BASE | 2019
|SISTEM PENGENALAN GESTURE TANGAN UNTUK KENDALI GERAK MOBILE ROBOT BERBASIS PENGOLAHAN CITRA
BASE | 2017