In 2016, Ontario Drive & Gear Limited (ODG) and Canadensys Aerospace Corporation completed the design and fabrication of a pair of small to mid-size lunar rover prototypes funded by the Canadian Space Agency (CSA). These lunar rover prototypes were intended to demonstrate the compatibility of the CSA’s rover architecture with higher technology readiness levels, with a target of achieving technology readiness level 6 (TRL-6) qualification for the driveline subsystem, including motors, gearboxes, structure, and a compliant, metallic wheel. To that end, a series of thermal vacuum (TVAC) tests was conducted at NASA Glenn Research Center (GRC) and NASA Langley Research Center (LaRC). The first test was conducted at NASA GRC in Cleveland, Ohio, in late 2015. The mid-size VF-13 vacuum chamber used at GRC allowed the equipment to be tested with a lunar simulant present under a variety of thermal scenarios. The drivetrain survived exposure to vacuum and temperature extremes from -175 °C to +130 °C and was driven approximately 30 km in a dusty environment at temperatures ranging from -70 °C to +130 °C. The design of the multi-stage non-contact dust seals was proven to be effective. During the first test campaign, one of the position sensor magnets in the motor was displaced after being subjected to -130 °C and then operated at +130 °C. A review of the motor design was conducted by the manufacturer and the design was subsequently improved to eliminate the failure mode. A subsequent vacuum test was conducted at NASA LaRC to ensure that the failure would not reoccur and that the motor would be able to withstand exposure to lunar night conditions. A motor module assembly, consisting of an updated motor, brake, and gearbox, was installed in the cryo-mechanisms chamber and connected to a dynamometer to apply load. A compliant metallic wheel was also installed in the chamber in a statically-loaded state. The motor was operated under load at temperatures ranging from -70 °C to +130 °C. Additionally, the motor was exposed to a minimum temperature of -242 °C overnight, after which it was again operated successfully at temperatures between -70 °C and +130 °C, with no degradation in performance observed. The wheel was subjected to temperatures ranging from -149 °C to +108 °C while under a load of approximately 647 N.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Cryogenic Vacuum Testing of Lunar Rover Drivetrain


    Beteiligte:
    Edmundson, Perry (Autor:in) / Visscher, Peter (Autor:in) / Newman, Josh (Autor:in) / O’Connell, Joseph (Autor:in) / Picard, Martin (Autor:in)

    Kongress:

    16th Biennial International Conference on Engineering, Science, Construction, and Operations in Challenging Environments ; 2018 ; Cleveland, Ohio


    Erschienen in:

    Erscheinungsdatum :

    2018-11-15




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Lunar rover

    WU YANQING / JIAO FANWEI / XI CHAO | Europäisches Patentamt | 2020

    Freier Zugriff

    Lunar rover

    LIU QIANG / LI JIAN / LIU GANG et al. | Europäisches Patentamt | 2024

    Freier Zugriff

    Moving system of lunar rover and lunar rover

    LIU ZHEN / GAO HAIBO / HU LANQING | Europäisches Patentamt | 2023

    Freier Zugriff


    Manned lunar rover

    SONG JIAFENG / WANG RUIXIANG / XU SHUCAI et al. | Europäisches Patentamt | 2023

    Freier Zugriff