The cutting tool performance was increased by improving their properties of material. This literature review presents the study of HSS, UTC, CTC Uncoated deep cryogenic treated tool and Deep cryogenic treated tool. The minimal work is carried out to analyze the Grey Relational Analysis (GRA) with the AISI 1045 steel in process for turning operation. The results obtain on untreated and deep cryogenic treated tools are compared. The grey relational analysis method is carried with the normalization, grey relational coefficient, deviation sequence, grade. At Final the grade is identified and with Minitab and Design of experiments (DOE) method is analyzed then for which means and signal to noise ratio is identified and rank identified. From the results obtained on the work, it was finalized that the deep cryogenic treated tool was higher up to an untreated tool in all conditions. This tool had a better benefit concerning the lower cutting force, lower cutting temperature, lower flank wear, lower surface roughness and better chip morphology.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Optimization of process parameters in turning of AISI 1045 steel using GRA


    Beteiligte:
    Ramalingam, Kamalakannan (Autor:in) / Parthiban (Autor:in) / Kalaivanan (Autor:in) / Dhivakar (Autor:in) / Palanivel, Anand (Herausgeber:in) / Megaraj, Meikandan (Herausgeber:in) / Packirisamy, Muthukumaran (Herausgeber:in)

    Kongress:

    5TH INTERNATIONAL CONFERENCE ON INNOVATIVE DESIGN, ANALYSIS & DEVELOPMENT PRACTICES IN AEROSPACE & AUTOMOTIVE ENGINEERING: I-DAD’22 ; 2022 ; Chennai, India


    Erschienen in:

    Erscheinungsdatum :

    07.06.2023


    Format / Umfang :

    7 pages





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Investigation into erosion rate of AISI 4340 steel during wire electrical discharge turning process

    Giridharan, Abimannan / Samuel, G. L. | British Library Online Contents | 2018


    Optimization of Cutting Parameters in Turning Process

    Ahmed, Imtiaz / Bhuiyan, Tanveer Hossain | SAE Technical Papers | 2014


    Nr. 1045

    DataCite | 1865

    Freier Zugriff


    Predicting Mechanical Properties of Friction Welded AISI 1020/AISI 1018 Steel and AISI 431/AISI 1018 Steel Joints

    Visvalingam, Balasubramanian / Thirumalaikkannan, Dhamothara Kannan / Murugesan, Seeman et al. | SAE Technical Papers | 2023