Based on the literature analysis of the work on the calculation of the components of the cutting force, an algorithm and program have been developed for the theoretical calculation of the components of the cutting force during thread milling with single-disk cutters using the parameters of the section of the cut layer. The influence of the parameters of the tool (diameter and angles of the cutting part), thread (diameters and pitch), and cutting mode (feed and cutting speed) on the value of the components of the cutting force during thread milling was investigated and a comparative analysis of the data obtained with the results of the experimental study, which confirmed the theoretical calculation.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Force modeling of thread milling


    Beteiligte:
    Malkov, O. V. (Autor:in) / Karelsky, A. S. (Autor:in) / Soloviev, Vladimir A. (Herausgeber:in) / Rogozin, Dmitry O (Herausgeber:in) / Aleksandrov, Anatoly A (Herausgeber:in) / Fedorov, Igor B (Herausgeber:in) / Mayorova, Vera I (Herausgeber:in)

    Kongress:

    XLV ACADEMIC SPACE CONFERENCE, DEDICATED TO THE MEMORY OF ACADEMICIAN S.P. KOROLEV AND OTHER OUTSTANDING NATIONAL SCIENTISTS — PIONEERS OF SPACE EXPLORATION ; 2021 ; Moscow, Russia


    Erschienen in:

    Erscheinungsdatum :

    20.07.2023


    Format / Umfang :

    8 pages





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch



    Thread milling

    Engineering Index Backfile | 1944


    Helicool thread milling solution

    Emerald Group Publishing | 2007



    Structure investigation and microhardness of the thread in thread milling and tapping process

    Malkov, O. V. / Malkova, L. D. / Dulnev, K. V. et al. | American Institute of Physics | 2023