This paper discusses the calculation and implementation of dampers systems on LAPAN-A4 satellite payloads. The LAPAN-A4 satellite payload consists of many components (electronic, mechanical, optical). In terms of resistance, these components are quite sensitive to vibrations. To avoid failure due to these vibrations, we have to make a damping system that can reduce the vibrations that will hit the payload. The method used in the damping system is use wire rope isolators (steel springs), this method was chosen because it is easier to calculate and install, the other considerations due to wire rope isolators are stable and not affected by extreme temperatures, chemicals, oil, ozone, and abrasive materials. Damping calculation of the wire rope isolator will produce some data, namely Total Supported Load (Wt), Numbers isolators (n), static load per isolator (W), excitation frequency (fi), system response natural frequency for 80% isolation (fn) and maximum isolator vibration stiffness (Kν). Based on the calculation, steel spring in the compression position obtained W= 34.78 N and Kν = 125.87 kN/m with a total of 34 springs. Whereas for the spring in the shear or roll position obtained W= 17.21 N and Kν = 15.57 kN/m with a total of 20 springs. The value of (Kν) compression and the (Kν) shear or roll obtained is sufficient to reduce vibrations that occur in the components in the payload. The results of this calculation are preliminary predictions of the design and configuration of the LAPAN-A4 payload, further testing needs to be done at the sub-system level as verification before implementation and testing at the satellite level with expectations that the LAPAN-A4 satellite payload components can receive vibration loads during launch.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Calculation and implementation of dampers for LAPAN-A4 satellite payloads


    Beteiligte:
    Kurniawan, R. (Autor:in) / Huzain, M. F. (Autor:in) / Kurniawan, Farohaji (Herausgeber:in) / Kurniawati, Frida (Herausgeber:in) / Bahri, Sayr (Herausgeber:in) / Santosa, Cahya Edi (Herausgeber:in) / Hasbi, Wahyudi (Herausgeber:in) / Septanto, Harry (Herausgeber:in) / Hermawan, Eddy (Herausgeber:in)

    Kongress:

    THE 8TH INTERNATIONAL SEMINAR ON AEROSPACE SCIENCE AND TECHNOLOGY – ISAST 2020 ; 2020 ; Bogor, Indonesia


    Erschienen in:

    Erscheinungsdatum :

    13.09.2021


    Format / Umfang :

    10 pages





    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch





    Implementation Of CAN Bus Communication To UART In LAPAN-A4 Satellite

    Hartono, Rommy / Syafrudin, A Hadi / Hasbi, Wahyudi et al. | IEEE | 2018


    Design Requirement of LWIR Optical Filter for LAPAN-A4 Satellite

    Hartono, Rommy / Ardianto, Dede / Salaswati, Sartika et al. | IEEE | 2019


    The Development of LAPAN-A3 Satellite Off-Nadir Imaging Mission

    Nurul Khamsah, Nova Maras / Utama, Satriya / Surayuda, Rise Hapshary et al. | IEEE | 2019