51–60 von 3,026 Ergebnissen
|

    Sliding Mesh Fan Approach Using Open-Source Computational Fluid Dynamics to Investigate Full Vehicle Automotive Cooling Airflows

    Guzman, Arturo / Vilchis Contreras, Eloy / Doroudian, Mark | SAE Technical Papers | 2023
    Cooling airflow is an essential factor when it comes to vehicle performance and operating safety. In recent years, significant efforts have ...
    Verlag: Society of Automotive Engineers , SAE International

    A CFD-Based Numerical Evaluation, Assessment and Optimization of Conjugate Heat Transfer for Aerodynamic Cooling of a Wheel-Hub-Motors in Micro-Mobility Vehicles

    Mambazhasseri Divakaran, Arun / Abo-Serie, Essam / Gkanas, Evangelos et al. | SAE Technical Papers | 2023
    parameters (Fins and air-vents/holes) in cooling the motor. Air vents and external fins on rotor–lid (rotor cover) has a greater effect on cooling ...
    Verlag: Society of Automotive Engineers , SAE International

    Influence of operating conditions on thermal requirements in gas turbine blades

    L.R., Marconi / F.A.F, Monhol / C.P.S., Silva | SAE Technical Papers | 2023
    its rotors through internal cooling technologies. By means of a thermodynamic modeling of the process and the use of the finite difference ...
    Verlag: Society of Automotive Engineers , SAE International
    Schlagwörter: Engine cooling systems

    Experimental Comparison of Diesel and Wet Ethanol on an Opposed-Piston Two Stroke (OP2S) Engine

    Bhatt, Ankur / Lawler, Benjamin / Gainey, Brian et al. | SAE Technical Papers | 2023
    hole size of the injector was not increased, and from evaporation-driven heat removal near top dead center. However, further optimization of ...
    Verlag: Society of Automotive Engineers , SAE International
    Schlagwörter: Combustion and combustion processes

    Extension and Calibration of BPR Function for Traffic Efficiency Based on MFD

    Shen, Wei / Liu, Xiang / Liu, Fasheng | Springer Verlag | 2023

    Considering temporal and spatial characteristics of traffic conditions, traffic efficiency is defined to indicate

     ...
    Schlagwörter: Transportation Technology and Traffic Engineering

    Impact of Thermal Barrier Coatings on Intake and Exhaust Valves in a Spark Ignition Engine

    Lawler, Benjamin / Gainey, Brian / Jiang, Chen et al. | SAE Technical Papers | 2023
    eliminating the open cycle charge heating penalty of traditional TBCs through a combination of low thermal conductivity and low volumetric heat ...
    Verlag: Society of Automotive Engineers , SAE International

    Analysis of the Thermodynamic Effects of a Plate Based on Numerical Simulations

    Qaisar, Abdul / Asary, Abdul Rab / Azeem, Naqash et al. | SAE Technical Papers | 2023
    exchanged between two mediums, the wall or material in-between them is exposed to extreme temperatures (high and low), commonly known as a cooling ...
    Verlag: Society of Automotive Engineers , SAE International

    Effect of Phase Change Material Dimension on Maximum Temperature of a Lithium-Ion Battery

    Morali, Uğur | Springer Verlag | 2023
    temperature within safe temperature limits. Results showed the effect of PCM width on the maximum battery temperature and temperature distribution ...
    Verlag: Springer International Publishing , Cham
    Schlagwörter: Aerospace Technology and Astronautics , Renewable and Green Energy , Energy Policy, Economics and Management

    Exploration of Fuel Property Impacts on the Combustion of Late Post Injections Using Binary Blends and High-Reactivity Ether Bioblendstocks

    Rothamer, David / Subramanian, Srinath | SAE Technical Papers | 2023
    In this study, the impacts of fuel volatility and reactivity on combustion stability and emissions were studied in a light-duty single ...
    Verlag: Society of Automotive Engineers , SAE International
    Schlagwörter: Combustion and combustion processes

    Experimental and Numerical Investigation of Spark Plug and Passive Pre-Chamber Ignition on a Single-Cylinder Engine with Hydrogen Port Fuel Injection for Lean Operations

    Kulzer, Andre / Vacca, Antonino / Sobek, Florian et al. | SAE Technical Papers | 2023
    12.2, port fuel injection and a conventional spark plug. Based on the results, the engine is operated with a passive pre-chamber to investigate ...
    Verlag: Society of Automotive Engineers , SAE International
    Schlagwörter: Combustion and combustion processes