Synonyme wurden verwendet für: Chemistry
Suche ohne Synonyme: International Journal of New Chemistry

1–16 von 16 Ergebnissen
|

    Structural reliability of a Suezmax oil tanker designed according to new common structural rules

    Soares, C.Guedes / Parunov, Josko | Tema Archiv | 2008
    with new CSR (Common Structural Rules ) requirement for ultimate vertical bending moment capacity. The probability of structural failure is ...

    Numerical assessment of fore-and-aft suspension performance to reduce whole-body vibration of wheel loader drivers

    Fleury, Gerard / Mistrot, Pierre | Tema Archiv | 2006
    displacement of the suspension are computed. A new suspension design with optimized features is proposed. Its performance is checked from calculations ...
    Schlagwörter: ISO (International Organization for Standardization)

    Coupled boundary and finite element analysis of vibration from railway tunnels - a comparison of two- and three-dimensional models

    Andersen, L. / Jones, C.J.C. | Tema Archiv | 2006
    The analysis of vibration from railway tunnels is of growing interest as new and higher-speed railways are built under the ground to ...

    Field studies of the effect of friction modifiers on short pitch corrugation generation in curves

    Eadie, Donald T. / Santoro, Marco / Oldknow, Kevin et al. | Tema Archiv | 2008
    observed that FM application reduced the rate of corrugation growth by a factor of 6-11 times. In most cases there were little or no new ...

    Microscopic Investigation of Vortex-Vortex Interaction in Conventional Superconductors

    Kato, Masaru / Niwa, Yuhei | Tema Archiv | 2012
    Quasi-particle structures around a pair of vortices and its effect on the vortex-vortex interaction are investigated. For this purpose, a ...

    Optimal design of wheel profiles based on weighed wheel/rail gap

    Cui, Dabin / Li, Li / Jin, Xuesong et al. | Tema Archiv | 2011
    contact point. Taking the wheel/rail counterpart, wheel LMa and rail CHN60 of China railway, as an example, the new optimization method is used to ...

    Design and modification of tool to manufacture rectangular cup of Ni-MH battery for hybrid cars

    Ku, T.W. / Kim, Y. / Kang, B.S. | Tema Archiv | 2007
    proposed a new tool design of the process through numerical simulation of drawing and ironing process with the thickness control of each wall of ...

    Comparison of crankshaft calculation methods with reference to classification societies' requirements

    Savolainen, Matti / Tienhaara, Hannu / Resch, Thomas et al. | Tema Archiv | 2010
    necessity for high reliability, especially for large engine crankshafts, on one hand, but new demands in sense of efficiency and costs on the other ...

    Adaptation of the ECFM combustion model to hydrogen internal combustion engines

    Knop, V. / Benkenida, A. / Jay, S. | Tema Archiv | 2006
    on fossil fuels. Most of these studies aims at adapting internal combustion engines to alternative fuels instead of developing new ones. This ...

    Proposal of electro-magnetic-suspension system with tilting control

    Chuang, Chih-Chung / Suda, Yoshihiro / Komine, Hisanao et al. | Tema Archiv | 2004
    This paper proposes a new Electro-Magnetic-Suspension (EMS) system, which has the ability of self-banking in curve section. This new EMS ...

    Nonlinear dynamic behavior of turbocharger rotor-bearing systems with hydrodynamic oil film and squeeze film damper in series: prediction and experiment

    Gjika, Kostandin / Groves, Chris / Andres, Luis San et al. | Tema Archiv | 2007
    under high oil inlet temperature and low feed pressure. The development of high performing bearing systems, marrying innovation with reliability ...
    Verlag: American Society of Mechanical Engineers (ASME) , New York

    The science of dynamic compression at the mesoscale and the Matter-Radiation Interactions in Extremes (MaRIE) project

    Barnes, Cris W. / Funk, David J. / Hockaday, Mary P. et al. | Tema Archiv | 2014
    A scientific transition is underway from traditional observation and validation of materials properties to a new paradigm where scientists ...

    Numerical prediction of rail roughness growth on tangent railway tracks

    Nielsen, J.C.O. | Tema Archiv | 2003
    Growth of railhead roughness (irregularities, waviness) is predicted through numerical simulation of dynamic train-track interaction on ...

    Extended validation of a theoretical model for railway rolling noise using novel wheel and track designs

    Jones, C.J.C. / Thompson, D.J. | Tema Archiv | 2003
    . Alongside this development, the theoretical model has been updated to improve accuracy and include new features. The results of 34 wheel/track ...

    A multi-Hertzian contact model considering plasticity

    Sebes, Michel / Chollet, Hugues / Ayasse, Jean-Bernard et al. | Tema Archiv | 2014
    Multi-body-system (MBS) simulation is widely used in the railway industry. One of its major topics is the assessment of rolling contact ...

    Reflections on RANS Modelling

    Spalart, P. | Tema Archiv | 2010
    demand. Key points are then drawn from a special RANS issue of International Journal of CFD, with the author as guest editor. The articles ...