1–20 von 174 Ergebnissen
|

    3-layered 3D flex based MCM: electrical characterization and reliability issues

    Morrison, W.B. / Railkar, T.A. / Malshe, A.P. et al. | Tema Archiv | 1999
    Polyimide flex is an accepted substrate material for commercial and specialized electronic packaging applications. The advantages of using ...

    20K-cryogenic-temperature satellite materials outgassing facility for ASTM-E1559 standard

    Bertrand, W.T. / Prebola, J.L. / Wood, B.E. | Tema Archiv | 2002
    This paper describes the development of a facility for material outgassing measurements using quartz crystal microbalances (QCMs) operating ...

    A bioinspired vision chip architecture for collision detection in automotive applications

    Laviana, R. / Carranza, L. / Vargas, S. et al. | Tema Archiv | 2005
    This paper describes the architecture and retino-topic unit of a bio-inspired vision chip intended for automotive applications. The chip ...

    Actuator development for a flapping microrobotic microaerial vehicle

    Cox, A. / Garcia, E. / Goldfarb, M. | Tema Archiv | 1998
    areas result in low Reynolds numbers. For Re's below 103 conventional fixed wing flight is no longer possible because drag becomes ...

    Adaptive position estimation for an automated guided vehicle

    Lapin, B.C. | Tema Archiv | 1992
    for an automated guided vehicle (AGV) to overcome these complexities. The scheme's purpose is to minimize the position error - the difference ...
    Verlag: SPIE International Society for Optical Engineering , Bellingham

    A deontic implementation of adjustable autonomy for command and control of robotic assets

    Lisse, S.A. / Beard, J.T. / Huber, M.H. et al. | Tema Archiv | 2006
    This paper describes a system for implementing adjustable autonomy levels in simulated unmanned vehicles using an approach based upon the ...

    Advanced MMI/MP for Demo III XUVs

    Balakirsky, S.B. / Salonish, M.J. / Allen, S.D. et al. | Tema Archiv | 1998
    This paper outlines the goals and work accomplished thus far for both the man-machine interface (MMI) and mission planning (MP) elements of ...

    A Franco-German unmanned countermine system demonstrator

    Le Gusquet, F. / Useo, F. / Marion, V. et al. | Tema Archiv | 2006
    (France) and THALES (France) for the joint development of a technology demonstrator for a vehicle-based close-in countermine system. The objective ...

    A localization system for a high-speed land vehicle

    Julier, S.J. / Durrant-Whyte, H.F. / Cooper, S.B. | Tema Archiv | 1998
    system for a conventional road vehicle operating in an outdoor environment at speeds in excess of 15 ms-1. Using sparsely placed ...

    Aluminum nitride coatings for protection of diamond at high-temperature in air

    McGeoch, S.P. / Waddell, E.M. / Clark, C.C. et al. | Tema Archiv | 1999
    . Advances in the performance of synthetic diamond made by chemical vapor deposition promise an expanding range of applications for the material. An ...

    A module type space manipulator

    Kimura, S. / Tsuchiya, S. / Nishida, S. et al. | Tema Archiv | 1999
    The Communications Research Laboratory has been studying the inspection technology needed for the first step of 'orbital maintenance system ...

    An adaptive localization system for outdoor/indoor navigation for autonomous robots

    Pacis, E.B. / Sights, B. / Ahuja, G. et al. | Tema Archiv | 2006
    of autonomous navigation for mobile robots has targeted either outdoor or indoor scenarios, but not both, which is not how humans operate ...

    Analysis of electric machines and drive systems for unmanned ground vehicle applications

    Wies, R.W. / Mitchell, J. / Daniels, S. et al. | Tema Archiv | 2000
    under all conditions so as to minimize the power consumption from limited power source. The concern for energy consumption and space limitations ...

    Analysis of laser-ranging technology for sense and avoid operation of unmanned aircraft systems: the tradeoff between resolution and power

    Euliss, G. / Christiansen, A. / Athale, R. | Tema Archiv | 2008
    An investigation of power and resolution for laser ranging sensors is performed in relation to sense and avoid requirements of miniature ...

    An application of holographic interferometry for dynamic vibration analysis of a jet engine turbine compressor rotor

    Fein, H. | Tema Archiv | 2003
    for data collection in either simulated flight operation test or computer-based modeling and simulations. Advanced optical holography ...

    An approach to full pose estimation for an automatic control system based on vision

    Khachaturov, G. / Moncayo, H. | Tema Archiv | 1998
    distributed features. The Fourier transform technique serves for measurements of mark image parameters conveying information about pose parameters ...

    An articulated robotic scanner for mine detection: a novel approach to vehicle mounted systems

    Das, Y. / Russell, K. / Kircanski, N. et al. | Tema Archiv | 1999
    the advantages of the two methods described above while minimizing the disadvantages of both. For example, it will have the flexibility of a ...

    An autonomous system for cross-country navigation

    Stentz, A. / Brunitt, B.L. / Coulter, R.C. et al. | Tema Archiv | 1992
    Autonomous cross-country navigation is essential for outdoor robots moving about in unstructured environments. Most existing systems use ...
    Verlag: SPIE International Society for Optical Engineering , Bellingham

    A new Ag/Pd conductor for automotive applications

    Malanga, D.J. / Levitsky, M. / London, A. et al. | Tema Archiv | 1999
    New materials and powder technology have been applied to conductor formulations targeted for the harsh environments of under the hood ...