FEA simulation and experimental validation of catalytic converter structural integrity
Failure modes investigation and analysis of electric power steering system with PMSM drives
Experimental identification of distributed damping matrices part 2: experimental case studies
Experimental identification of distributed damping matrices part 1: analytical case studies
Evaluation of crash protection for hybrid electrical vehicle under rear impact
Dynamic state battery modeling of energy and power as the state variables for EV application
Dual-arm dynamic motion simulation and prediction of joint constraint loads using optimization
Development of wear-resistant piston ring groove designs for large two-stroke engines
Development of the virtual test technology for evaluating thermal performance of disc brake
Development of rollover prevention system using unified chassis control of ESP and CDC systems
Development of Mandos new continuously controlled semi-active suspension system
Development of interactive dynamic simulation method for evaluation truck ride
Development of electronic controlled four wheel drive vehicle by using performance analysis tool
Development of driving control system based on optimal distribution for a 6WD/6WS vehicle
Detection of hybrid and quiet vehicles by blind and visually impaired pedestrians
Deformation analysis and optimization of an automotive wheel bearing seal lip
Control analysis and thermal model development for plug-in hybrid electric vehicles
Combustion system for full-time gasoline direct-injection compression-ignition ( GDCI )
Characterization of catalytic converter mat material for predictive analysis