1–20 von 44 Ergebnissen
|

    Formulation of pressure sensitive paints for unsteady measurements

    Soumagne-Schweyckart, I. / Merienne, M.-C. / Ancelle, J. | IEEE | 2001
    pyrene derivative covalently linked to silica particles. The grafted silica is mixed with a water soluble alumina and can be sprayed with an ...

    Regeneration of cryosorbing exhaust gas panels by means of gyrotron radiation

    Mobius, A. / Mack, A. / Day, C. et al. | IEEE | 2002
    to be disconnected from the vessel and rapidly heated (during 75 s) to 80-100 K to regenerate the surface. After heating, rapid cooling down ...

    Progress of the 1 MW, 140 GHz, CW gyrotron for W7-X

    Dammertz, G. / Alberti, S. / Arnold, A. et al. | IEEE | 2002
    better cooling and an additional relief window at the mirror box has been built and tested. Without optimisation of the parameters in short and ...

    Radial profiles of arcjet flow properties measured with laser-induced fluorescence of atomic nitrogen

    Grinstead, J.H. / Driver, D.M. / Raiche, G.A. | IEEE | 2003
    the NASA Ames Aerodynamic Heating Facility (AHF) are reported. Improvements in experimental technique and calibration procedure significantly ...

    Ultimate cold-electron bolometer for THz applications

    Kuzmin, L. | IEEE | 2004
    ), an unavoidable dc heating for electrothermal feedback is replaced by deep electron cooling removing all incoming power from the absorber to ...

    Recent results of ECH diamond window development

    Takahashi, K. / Illy, S. / Heidinger, R. et al. | IEEE | 2004
    Resent results of a diamond window development for an electron cyclotron heating (ECH) system are reported. High power millimeter wave ...

    Design and test of a remote steering upper port launcher for ITER

    Verhoeven, A.G.A. / Elzendoorn, B.S.Q. / Bongers, W.A. et al. | IEEE | 2005
    , the RS launching system enables to do maintenance on the system during shutdown, without affecting the torus vacuum and the blanket cooling ...

    Multi-beam CO/sub 2/ lasers and theirs applications

    Glova, A.F. / Drobyazko, S.V. / Likhanskii, V.V. | IEEE | 2005
    Description of the design and radiation parameters of multi-beam CO/sub 2/ lasers with a diffusion gas cooling and with an ac discharge ...

    Testing Needs for ITER ECH Transmission Line Components

    Olstad, R.A. / Doane, J.L. / Callis, R.W. | IEEE | 2006
    The performance requirement of 1 (possibly 2) MW cw at 170 GHz for ITER Electron Cyclotron Heating and Current Drive transmission line ...

    The Primary Design of ECU for EAST

    Tonghai, Ding | IEEE | 2006
    one of the most important plasma heating and current driving methods for EAST. After referring to ECH systems operating on the other devices ...

    Experimental Analysis on the Measurement of Ballistic Properties of Solid Propellants

    Curdaneli, S. / Ak, M.A. / Ulas, A. | IEEE | 2007
    determine the ballistic properties of the propellant at different environmental conditions. Auxiliary systems such as Cryogenic Cooling System and ...

    Nonlinear control of vaporized cooling level

    Wei Huang, / Qiang He, / Qiaoli Huang, et al. | IEEE | 2008
    In the converter steelmaking vaporized cooling process, the serious “false water level” phenomenon appears at the drum water ...

    Numerical simulation for aerodynamic heating and opposing jet thermal protection

    Lv Hongqing, / Wang Zhenqing, / Jin Chengbin, et al. | IEEE | 2008
    Based on the theory and semi-empirical formulas, the surface heating flux of warhead at zero attack angle under aerodynamic heating is ...

    Modeling and analysis of MEMS-based cooling system for nano-satellite active thermal control

    Liu, Jia / Li, Yunze / Wang, Jun | IEEE | 2008
    liquid cooling system and classical PID control law can satisfy the cooling requirements of on-orbit nano-satellite thermal system with high ...

    Reentry trajectory planning optimization based on sequential quadratic programming

    Zhang Qingzhen, / Gao Chen, / Guo Fei, et al. | IEEE | 2008
    An optimal trajectory is very important to reusable launch vehicle (RLV) which facing the critical heating and aero force in reentry ...

    New opportunities for using solar energy in Lithuanian disctrict heating companies

    Grigoniene, Jurgita / Lisauskas, Aurimas / Kveselis, Vaclovas | IEEE | 2014
    Energy production using renewable energy sources is one of the main priorities in EU energy policy. Exhaustive analysis on district heating ...

    Thermal management of fuel cell-driven vehicles using HT-PEM and hydrogen storage

    Nasri, Mounir / Dickinson, Dave | IEEE | 2014
    many years. In this work a system for hydrogen storage for the heating and cooling of a high temperature polymer membrane fuel cell range ...

    Increasing efficiency of ecological vehicles by integrating auxiliary units directly to the traction shaft

    Satheesh Kumar, N. / Schier, Michael | IEEE | 2014
    countries require heating during the winter season, while those operated in equatorial regions face cooling load throughout the year. To date, the ...

    Minimization of energy needs in the industry of electric drives manufacturing considering process-related temperature curves

    Kohl, Johannes / Spreng, Simon / Hofmann, Benjamin et al. | IEEE | 2014
    processes is often only based on the product quality, in practice a lot of consecutive heating up and cooling down phases can be observed leading to ...

    Influences of different heating strategies on the energy demand of an airfield luggage tug

    Hubner, Markus / Schmitt, Michael / Schier, Michael | IEEE | 2015
    luggage tug has been created using Alternative Vehicles Library in Dymola. Heating concepts based on fuel cell thermal waste heat and conventional ...