Synonyme wurden verwendet für: Modellmethode
Suche ohne Synonyme: keywords:("Modellmethode")

1–10 von 21,522 Ergebnissen
|

    0D/1D Turbulent Combustion Model Assessment from an Ultra-Lean Spark Ignition Engine

    Kusaka, Jin / Yamaguchi, Kyohei / Sok, Ratnak | SAE Technical Papers | 2019
    Schlagwörter: Simulation and modeling

    1D/3D Comparison of Flow Field Simulations Inside an Exhaust-Type Duct

    Nanni, Daniele / Romoli, Marco / Rossi, Riccardo et al. | SAE Technical Papers | 2007
    Schlagwörter: Simulation and modeling

    1-D Dynamic Modeling and Sensitivity Analysis in Product Design

    Michelotti, Alvaro C. / da Silva, Jonny C. | SAE Technical Papers | 2008
    Schlagwörter: Simulation and modeling

    1D Engine Simulation Approach for Optimizing Engine and Exhaust Aftertreatment Thermal Management for Passenger Car Diesel Engines by Means of Variable Valve Train (VVT) Applications

    Özyalcin, Can / Bergmann, Dirk / Deppenkemper, Kai et al. | SAE Technical Papers | 2018
    Schlagwörter: Simulation and modeling

    1D Fluid Dynamic Modeling of Unsteady Reacting Flows in the Exhaust System with Catalytic Converter for S.I. Engines

    Onorati, A. / D'Errico, G. / Ferrari, G. | SAE Technical Papers | 2000
    Schlagwörter: Simulation and modeling

    1-D MODEL DEVELOPMENT TO STUDY THE DYNAMIC BEHAVIOR OF THE MECHANICAL DIODE CONFIGURATION APPLIED TO ONE-WAY CLUTCH (OWC)

    Michelotti, Alvaro C. / da Silva, Jonny C. | SAE Technical Papers | 2009
    Schlagwörter: Simulation and modeling

    1D Model for Correcting the Rate of Injection Signal Based on Geometry and Temperature Influence

    Bebber, David van / Reuter, Uwe | SAE Technical Papers | 2017
    Schlagwörter: Simulation and modeling

    1-D Modeling and Room Temperature Experimental Measurements of the Exhaust System Backpressure: Limits and Advantages in the Prediction of Backpressure

    Pazé, Costanza / Gambarotto, Massimiliano / BossÙ, Roberto et al. | SAE Technical Papers | 2008
    Schlagwörter: Simulation and modeling

    1D Modeling of AC Refrigerant Loop and Vehicle Cabin to Simulate Soak and Cool Down

    Amaral, Ricardo / Rahman, Sadek / S, Sathish Kumar et al. | SAE Technical Papers | 2013
    Schlagwörter: Simulation and modeling

    1D Modeling of Expansion tank Flow

    Sathish Kumar, S / Arthanari, Tharunnarayanan / Sundaram, V | SAE Technical Papers | 2015
    Schlagwörter: Simulation and modeling