Design, Fabrication, and Testing of Metallic Thermal Protection Systems for Spaceplane Vehicles
Sizing and Margins Assessment of Mars Science Laboratory Aeroshell Thermal Protection System
Spectrally Filtered Imaging and Vacuum Ultraviolet Spectroscopy of Preheated Models in X2
Effects of Aggregated Sphere Distribution and Percolation on Thermal Conduction of Nanofluids
On the Definition of Exergy in the Field of Aerodynamics
Evaluating Enhanced Boiling Heat Transfer in a Novel Grooved Tube
Pre- and Postflight Thermal Analysis of Test Launch Vehicle Fuselage
Development of an Experimental Small Loop Heat Pipe with Polytetrafluoroethylene Wicks
Development and Theoretical Analysis of an Aircraft Supercooled Icing Model
Numerical Modeling of Earth Reentry Flow with Surface Ablation
Experimental Study on Pressure Drop of Aluminum-Oxide/Water Nanofluids
Experimental Study of Graphite Ablation in Nitrogen Flow, Part II: Further Numerical Analysis
Thermal Protection System Crack Growth Simulation Using Advanced Grid Morphing Techniques
Gravity Orientation Effects on Convection in the Gap Between Partially Heated Cylinders
Investigation of Heat Transfer to a Pulsating Flow in Plate Heat Exchangers
Effect of Gravity on Ice-Layer Growth in a Freezable Heat Exchanger
Temperature Jump Phenomenon During Plasmatron Testing of ZrB2-SiC Ultrahigh-Temperature Ceramics
Ramp Heating in High-Speed Transient Thermal Measurement with Reduced Uncertainty
Exergy Balance Decomposition Between Mechanically- and Thermally-Recoverable Exergy Outflows
Influence of Cooling-Gas Properties on Film-Cooling Effectiveness in Supersonic Flow
Performance Characterization of Laminar Flow in Multiple Microjet Impingement Heat Sinks
Thermal Protection System Response Uncertainty of a Hypersonic Inflatable Aerodynamic Decelerator
European Experimental Reentry Testbed Winglet: From In-Flight Characterization to SCIROCCO Test
Effect of Nanofluid on Entropy Generation and Pumping Power in Coiled Tube
Effects of Wall-Temperature Conditions on Effusion Cooling in a Supersonic Boundary Layer
Coherent Anti-Stokes Raman Spectroscopy of a Hydrogen Diffusion Flame in a Ramjet
Methodology for Geometric Optimization and Sizing for Subnewton Monopropellant Catalyst Beds
Feasibility Study of Aerocapture at Mars with an Innovative Deployable Heat Shield
Numerical Modeling and Parametric Study of the Melting Behavior of Ice Crystal Particles
Film Cooling Overall Effectiveness of Shaped Holes at Elevated Temperatures
Optical Method for Measuring Low Wall Shear Stresses Using Thermal Tufts
Vibrational-Specific Model of Simultaneous and Relaxation Under Postshock Conditions
Prediction of Partial Miscibility of Binary Mixtures Consisting of Ionic Liquids
Performance Characterization of a Natural Gas–Air Rotating Detonation Engine
An Experimental Study of Thermochemical Nonequilibrium
Empirical Modeling of Copper Catalysis for Enthalpy Determination in Plasma Facilities
Effect of Waveform Channel on the Cooling Performance of Hybrid Microchannel
Development and Verification of Nonequilibrium Reacting Airflow Modeling in ANSYS Fluent
Assessment of Aerocapture for Orbit Insertion of Small Satellites at Mars
Graphite Ablation and Radiation on Interaction with Hypervelocity Earth-Entry Flows
Heat Transfer and Pressure Drop Measurements of Rotating Rib-Roughened Parallelogram Channel
Experimental Assessment of Hypersonic Convective Heat Transfer Augmentation due to Surface Roughness
A Compact Icing Research Tunnel for Ice Adhesion Characterization
Evaluation of Wavy-Trailing-Edge Film Cooling Versus Pressure Side Cutback Cooling
Groove Coating's Effect on Linear and Nonlinear Instability of High-Speed Boundary Layer
Temporal Instability of a Confined Liquid Film with Heat and Mass Transfer