2002-01-0777 Primary Study of Applying Acupuncture to Reduce Driver Postural Muscle Fatigue
2009-01-1535 Intelligent Control of Metal-belt CVT Based on Fuzzy Logic
Active CO2 Two-Phase Loops for the AMS-02 Tracker
Active control of flow-induced cavity oscillations
Active control of flow-induced cavity oscillations
A Model-Based Design for Electronic Control Unit of Electric Motorcycle F2012-D03-002
A More Flooding-Tolerant Oxygen Electrode in Alkaline Electrolyte
Amplification characteristics of Nd-doped fluoride glass fiber at 1.3-m wavelength [2996-27]
Analysis of the Influence of Clutch Pedal to Vehicle Comfort F2012-C01-002
Analysis of vehicle dimension definition and proportion of coordination on chinese market
A New Approach to the Presentation of Vibration Phenomena in Vehicles F2012-J08-002
A Novel Concept of High Voltage Auxiliaries and its Feasibility Study on Blower Motors F2012-D02-018
A Numerical and Experimental Study of the Factors that Influence Heat Partitioning in Disc Brakes
Application of Energy Distribution Analysis During the Vehicle Development
Application of Stiffness Estimation and Structure Optimization in Rubber Component Development
Application of Stiffness Estimation and Structure Optimization in Rubber Component Development
A Study of Contact Condition in Vehicle Transmission Virtual Assembly System
A Study on Battery Model Verification Using Battery HILS
A Study on Effective Thermal-Shock Test Improvement of Battery Packs for PHEVs F2012-B03-025
A Study on Effective Thermal-Shock Test Improvement of Battery Packs for PHEVs F2012-B03-025
Automatic Underwater Vehicle Landing on Deep-Ocean Floor by Successive Trajectory Learning Control
Collaborative Multi-Modality Target Classification in Distributed Sensor Networks
Comparison of Schlieren and Laser Scattering Methods in Wall-Film Model Validation
Comparison of Temperature Dependent Electroluminescence of InGaN/GaN and AlGaInP Based LEDs
Computation and calibration of wavelengths in the DOAS system [4414-97]
Continuous twisted nanofiber yarns fabricated by double conjugate electrospinning
Control and Simulation of Regenerative Suspension Using Permanent Magnetic Synchronous Motor
Control and Simulation of Regenerative Suspension Using Permanent Magnetic Synchronous Motor
Design and space qualification of laser for laser altimeter