1–7 von 7 Ergebnissen
|

    Engineering, simulation and part-design for new TWIP-steels in automotive car body crash systems

    Schneider, Matthias / Otto, Manuel / Gramling, Markus | Tema Archiv | 2014
    challenges in lightweight design and the potential of these new TWIP steels. Engineering steps and finite element simulations for a side-impact beam ...

    Lightweight potential and structural optimization of components made of steel-FRP-hybrid

    Prechtl, Gerhard / Schröder, Kai-Uwe / Schagerl, Martin | Tema Archiv | 2014
    on this state, an optimization of the design principle and optimal choice of material can be performed. In case of small structural indices ...

    Fabrication of Load Optimized Truck Members with Variable Cross Sections by Flexible Roll Forming

    Sedlmaier, Albert / Hennig, Roland / Abee, Andre | Tema Archiv | 2011
    of cars and trucks by more than 20%. Once a tool set for a part is produced, new dimensions of other parts of the same family could be ...

    High alloyed FeMnAlSi-steel - automotive lightweight potential for complex parts

    Otto, M. / Roser, R. / Brückner, T. | Tema Archiv | 2014
    Salzgitter AG has made a further step in the area of TWIP-steels and the result is a density-reduced iron-manganese-aluminum-silicon alloy ...

    FutureSteelVehicle - leading edge innovation for steel body structures

    Peruzzi, Martin / Gauriat, Antoine / Hoffmann, Oliver et al. | Tema Archiv | 2011
    Harshness) and stiffness targets. This was achieved using advanced and ultra high-strength steels (AHSS, UHSS), engineering design optimization and ...

    Vehicle Structure Innovations by Advanced Rollformed Solutions

    Wurzer, Robert / Biegel, Philipp / Till, Edwin T. | Tema Archiv | 2011
    strength steels the need becomes more obvious to correctly assess the parts in early design phases and to consider the mechanical behavior of any ...

    Injection Lines tor Diesel Engines - Simulation-based fatigue strength engineering

    Zimmermann, Steffen / Ostermann, Alfred / Bremer, Lars et al. | Tema Archiv | 2011
    In the paper, the actual situation of the market for Diesel injection lines has been discussed and the role of autofrettage pressure ...