A non-reflecting boundary for use in a finite element beam model of a railway track
Characterizing Wheel Flat Impact Noise with an Efficient Time Domain Model
Time-domain prediction of impact noise from wheel flats based on measured profiles
Sensor placement method for dynamic response reconstruction
On selection of primary modes for generation of strong internally resonant second harmonics in plate
An investigation of a two-stage nonlinear vibration isolation system
3D CFD modeling of a biodiesel-fueled diesel engine based on a detailed chemical mechanism
Research on Spacecraft Single-phase Fluid Loop Control Algorithm
Resonance frequency response of geometrically nonlinear micro-switches under electrical actuation
Particle Morphology and Size Results from the Smoke Aerosol Measurement Experiment-2
Bivariate empirical mode decomposition and its contribution to wind turbine condition monitoring
Dyno test investigations of gasoline engine fueled with butanol-gasoline blends
2009-01-0321 Life Cycle Assessment of Traffic Emission Reduce
Nonlinear vibration of edge cracked functionally graded Timoshenko beams
Free and forced vibration of cracked inhomogeneous beams under an axial force and a moving load
Damage prediction of rotating blades using displacement residuals
An embedded sensitivity approach for diagnosing system-level vibration problems
Free vibration and parametric resonance of shear deformable functionally graded cylindrical panels
RITZ VECTOR APPROACH FOR STATIC AND DYNAMIC ANALYSIS OF PLATES WITH EDGE BEAMS
DYNAMIC RESPONSE OF A HORIZONTALLY CURVED BEAM SUBJECTED TO VERTICAL AND HORIZONTAL MOVING LOADS
Cold Discharge of CF~3I in a Simulated Aircraft Engine Nacelle
IMPACT RESPONSE OF BRIDGES WITH ELASTIC BEARINGS TO MOVING LOADS
FREE AND FORCED VIBRATION OF REISSNER-MINDLIN PLATES WITH FREE EDGES RESTING ON ELASTIC FOUNDATIONS
FLOW-INDUCED VIBRATIONS OF SHEAR-DEFORMABLE LAMINATED PLATES EXPOSED TO AN OSCILLATING FLOW
Letters to the Editor - Semi-active flutter control by structural asymmetry
Tracer fuel injection studies on exhaust port hydrocarbon oxidation: part II