A study was conducted to evaluate the feasibility of compacting unbound aggregate base courses in lifts thicker than those permitted by state departments of transportation (DOTs). At present, the majority of the state DOTs allow a maximum lift thickness of 20.3 cm (8 in.) or less. Work conducted in conjunction with the widening of a state road in Georgia is described. Three test pads of the same base material were constructed and evaluated: one Target Strip and two Test Sections. The Target Strip was placed in two lifts: a 17.8-cm (7-in.) lift followed by a 15.2-cm (6-in.) lift. Each test section was constructed in a single, 33-cm (13-in.) lift. Compaction of the unbound aggregate base courses was evaluated by conventional nuclear density gauge (NDG) testing. Additionally, nondestructive seismic testing was used to evaluate stiffness profiles within the base and supporting subgrade. Spectral-analysis-of-surface-waves (SASW) tests were used for this purpose. Both the NDG and the SASW test results show that a 33-cm (13-in.)-thick layer of unbound aggregate base can be compacted as dense and as stiff as a 15-cm (6-in.)-thick layer. The seismic results also show that the upper 7.6 cm (3 in.) of all three test pads have lower stiffnesses than the bottom 25.4 cm (10 in.). This near-surface layer exhibits a lower stiffness, presumably from lower effective stresses and possibly from some disturbance caused by the compaction equipment. Also, higher moisture contents during compaction of the base yielded lower stiffnesses, even at the same in situ density.
Evaluation of Constructing Increased Single-Lift Thicknesses of Unbound Aggregate Bases Case Study in Georgia
Transportation Research Record
Transportation Research Record: Journal of the Transportation Research Board ; 1673 , 1 ; 95-102
1999-01-01
Aufsatz (Zeitschrift)
Elektronische Ressource
Englisch
Evaluation of Unbound Aggregate Base Layers using Moisture Monitoring Data
Transportation Research Record | 2019
|