The article presents an analysis of the car engine loads. The aim of the analysis was to determine the parameters of the brake / electric motor on an engine test bad. Analysis of loads on the driving tests concerned on chassis dynamo to simulate them on an engine dynamometer. To check the range of dynamometer shaft angular acceleration inertial mass of a car was reduced on the crankshaft axis. The calculations of maximum shaft acceleration were performed. Also the whole car acceleration when pulling away from the place was calculated. Calculations were verified by experiment on road. They both gave a good agreement.


    Zugriff

    Zugriff prüfen

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    The Initial Selection of Parameters for Dynamic Brake for Car Engine Test Dynamometer



    Erschienen in:

    Erscheinungsdatum :

    2013-12-13


    Format / Umfang :

    6 pages




    Medientyp :

    Aufsatz (Zeitschrift)


    Format :

    Elektronische Ressource


    Sprache :

    Englisch




    Brake test dynamometer programming

    Hatch,D. / Moore,M.W. / Ferodo,GB | Kraftfahrwesen | 1978


    Brake Test Code--Inertia Dynamometer

    SAE Technical Papers | 2002


    Brake dynamometer

    Takahashi, M. | Tema Archiv | 1979


    Correlating Dynamometer and Vehicle Brake Test Results: Brake Squeal

    Abendroth, Harald / Schwarz, Uwe | SAE Technical Papers | 2001