An experimental investigation was conducted with injection molded magnets for use with Hall sensors in automotive applications. Two groups of nylon 6 based and one group of nylon 12 based magnets, each containing approximately 88 percent strontium-ferrite, were exposed to a variety of environmental conditions (long term exposure to air, oil, transmission fluid at elevated temperature). The tensile strength and elongation of the magnets were monitored and recorded. It was found that there was a significant difference in the performance of the two nylon 6 based groups. The nylon 12 based group exhibited a performance consistent with the expectations. In designing with injection molded magnets, one must take into consideration the changes in properties as a function of environmental effects.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Testing and evaluation of injection molded magnets in engine and ignition environments


    Weitere Titelangaben:

    Untersuchung und Bewertung von spritzgegossenen Magneten in Motoren- und Zündungsbereichen


    Beteiligte:
    Lugosi, R. (Autor:in) / Furst, R. (Autor:in) / LaCroix, M. (Autor:in)

    Erschienen in:

    Erscheinungsdatum :

    1992


    Format / Umfang :

    13 Seiten, 16 Bilder, 2 Quellen



    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch





    Testing and Evaluation of Injection Molded Magnets in Engine and Ignition Environments

    LaCroix, Mark / Furst, Robert / Lugosi, Robert | SAE Technical Papers | 1992


    Simulation of thin-walled injection molded magnets

    Nguyen, Minh / Schinkothe, Wolfgang | IEEE | 2014



    Direct injection ignition assisted alcohol engine

    LoRusso,J.A. / Cikanek,H.A. / Ford Motor,US | Kraftfahrwesen | 1988