This paper presents an evaluation on elastomeric mount used to isolate vibration from powertrain to chassis or structure vehicle. The assessments started with measurement of noise inside compartment, and exhaust noise. This is followed by the measurement of vibration on both sides of elastomeric mounts. The noise in the compartment and exhaust noise is measured according to BS 6086: 1981 and BS ISO 5130: 2007. The noise in the compartment and vibration is tested in three conditions. Firstly, engine is run-up with load (driving at second gear); secondly, without load; and thirdly, without load but hanging. A microphone is fixed at the ear of the mannequin. The fast response and A weighting sound level meter were used for measurement noise in the compartment and exhaust noise. The vibration is measured in terms of acceleration on both sides of each elastomeric powertrain mounts. Two accelerometer transducers are fixed on both sides of powertrain elastomeric mounts. One side was identified as a source of vibration and the other as receiver of vibrations. The results showed that the pattern of overall vibration level on source and receiver increased from 1050 RPM (idling) to 4000 RPM on all test conditions. Vibration transmitted to chassis or receiver structure was analyzed using transmissibility concept. By evaluating test condition of engine run-up without load, informed that the front and rear mounts showed a high level transmissibility contributing to structure-borne noise.


    Zugriff

    Zugriff über TIB

    Verfügbarkeit in meiner Bibliothek prüfen

    Bestellung bei Subito €


    Exportieren, teilen und zitieren



    Titel :

    Measurement of Noise inside the Compartment and Vibration on both Sides of Elastomeric Powertrain Mounts of Passenger Car




    Erscheinungsdatum :

    2013


    Format / Umfang :

    5 Seiten




    Medientyp :

    Aufsatz (Konferenz)


    Format :

    Print


    Sprache :

    Englisch




    Measurement of Vibration Power Flow through Elastomeric Powertrain Mounts in Passenger Car

    Rejab, Mohd Noor Arib / Rahman, Roslan Abdul / Hamzah, Raja Ishak Raja et al. | Tema Archiv | 2013


    PNEUMATICALLY TUNED VEHICLE POWERTRAIN MOUNTS

    MATHAI THOMAS / DAKHLALLAH HASSAN / KING NIGEL et al. | Europäisches Patentamt | 2016

    Freier Zugriff

    NVH Design Criterion of Electric Powertrain Mounts

    Kang, Qiang / Gu, Perry | Springer Verlag | 2020


    NVH Design Criterion of Electric Powertrain Mounts

    Kang, Qiang / Gu, Perry | TIBKAT | 2020


    Noise and vibration control measures in the powertrain of passenger cars

    Schwibinger,P. / Hendrick,D. / Wu,W. et al. | Kraftfahrwesen | 1991